Bosch Rexroth IndraDrive MPH-02 Functional Description page 56

Firmware for drive controllers

Hide thumbs

page of 728

/ 728
Contents
Table of Contents
Bookmarks

Table of Contents

Master Communication

drive address

"Enter" button

"Esc" button

commands/settings

"Down" button

extended display

The address is set via the control panel as follows:

1. change to "commands/settings" mode

standard display

Activating the "commands/settings" mode

2. select element "2.1 drive address" by means of "Up/Down" buttons,

then confirm by means of "Enter" button

3. set drive address by means of "Up/Down" buttons, then confirm by

means of "Enter" button

• first set tens digit:

→ the display reads "2.1.1 drive address"

• then set units digit:

→ the display reads "2.1.2 drive address"

The tens or units digit is accepted by pressing the "Enter"

button. To return press the "Esc" button.

"Enter" button

"Esc" button

explanation:

Selecting and setting the drive address

Address Setting via Parameter

The drive address can also be set by writing the P-0-4025, Drive address

of master communication parameter. This is particularly interesting if

you administrate the axis data in centralized form in the control unit and

want to set the address from the control unit when replacing devices.

See also "Notes on How to Replace the Devices" in chapter "Handling,

Diagnostic and Service Functions"

MPH-02, MPB-02, MPD-02

commands/settings

press "Enter"

extended display

"Enter" button

"Esc" button

set tens digit with "Up/Down"

accept with "Enter" button

display changes (flashes)

between "Y.Y" and "XXXXXXXX"

ZE ... tens/units ("Zehner/Einer") digit of drive

DOK-INDRV*-MP*-02VRS**-FK01-EN-P

set units digit with "Up/Down"

Bosch Rexroth IndraDrive MPH-02 Functional Description page 56

Related Manuals for Bosch Rexroth IndraDrive MPH-02

Related Products for Bosch Rexroth IndraDrive MPH-02

This manual is also suitable for:

Table of Contents