Table of Contents
Related Manuals for Miele DA 5330 D
Summary of Contents for Miele DA 5330 D
- Page 1 Operating and installation instructions Cooker hood DA 5330 D To avoid the risk of accidents GiWOZ or damage to this appliance it is essential to read these instructions before it is installed and used for the first time. M.-Nr. 07 054 700...
-
Page 2: Table Of Contents
Contents Caring for the environment ......... . 3 Warning and Safety instructions . -
Page 3: Caring For The Environment
Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. -
Page 4: Warning And Safety Instructions
Warning and Safety instructions This appliance is not intended for This appliance complies with all use by persons (including children) relevant local and national safety with reduced physical, sensory or requirements. Inappropriate use mental capabilities, or lack of can, however, lead to personal injury experience or knowledge, unless they and damage to property. - Page 5 Miele authorised person in on the data plate correspond with the accordance with current national and on-site electricity supply, otherwise the local safety regulations.
- Page 6 Warning and Safety instructions Do not connect the appliance to Using at the same time as other the mains electricity supply by an heating appliances that depend on extension lead. the air from the room Extension leads do not guarantee the required safety of the appliance (e.g.
- Page 7 The Miele DSM 400 control module be switched on when the heating offers the possibility of combining other appliance is switched off or vice versa.
-
Page 8: Correct Use
Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you Never use an open flame beneath will avoid the risk of grease and dirt the cooker hood. To avoid the getting into the appliance and danger of fire, do not flambé... - Page 9 All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use.
-
Page 10: Guide To The Appliance
Guide to the appliance... - Page 11 To activate the run-on option. The fan f Grease filters can be set to continue running, and to g Cover panels Miele DDI 5330 switch off automatically after either 5 or 15 minutes. (optional accessory) l Touch control for the...
-
Page 12: Mode Of Operation
Mode of operation The cooker hood works with . . . air extraction: The air is drawn in, cleaned by the grease filters and directed outside. The cooker hood is fitted with a non-return flap in each of the towers. These close closed when the cooker hood is switched off. -
Page 13: Operation
If the cooker hood has been connected to a window contact switch via two Miele DSM 400 control modules, then the fans ^ Press the run-on option control for cannot be switched on if the window approx. -
Page 14: Run-On Option
Operation Run-on option It is advisable to leave the fan running for a few minutes after cooking has finished to neutralise any lingering The indicator lamps for fan power levels odours in the air. I and IV will flash if the automatic The fan can be set to switch off switch-off for the Intensive setting is not automatically after either 5 or 15... -
Page 15: To Switch The Hob Lighting On
Operation To switch the hob lighting on Safety cut-out The hob lighting can be switched on Should the cooker hood be left on, the and off independently of the fan. fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the hob lighting control ^ Pressing the On/Off control will switch to switch on the hob lighting. -
Page 16: Filter Operating Hours Counter
Operation Filter operating hours counter Reading the grease filter operating hours counter The number of hours the appliance has been in operation is stored in memory. To check the percentage of time set already used: The operating hours counter tells you when the grease filters need to be cleaned. - Page 17 Operation Altering the grease filter operating hours counter The grease filter operating hours counter is set at the factory for 30 The – / + indicator lamps show the hours. This can be lengthened or time which has been set: shortened to suit the type of cooking 1st lamp from the left = 20 hours you do.
-
Page 18: Cleaning And Care
It can Stainless steel surfaces can be cleaned be washed 300 times. using the Miele E-Cloth or with a suitable, non-abrasive, proprietary Housing cleaning agent, following the manufacturer's instructions on the General packaging. -
Page 19: Grease Filters
Cleaning and care Important for appliances with An oversaturated filter is a fire lacquered housing hazard. (special order finish) If cover panels are fitted as an optional It is very difficult to clean this type of extra, these need to be removed first. surface without causing minor marks to the surface material. - Page 20 Cleaning and care Cleaning the grease filters by hand When putting the grease filters back in position, ensure that the locking clips ^ Clean the filters with a soft nylon are facing down towards the hob. brush in a mild solution of hot water and a little washing-up liquid.
-
Page 21: Changing A Halogen Lamp
Cleaning and care Changing a halogen lamp Before any cleaning or maintenance work is carried out, the cooker hood must be disconnected from the mains supply. Ensure that: – it is switched off at the isolator, or – it is switched off at the wall socket and the plug removed, or –... -
Page 22: Appliance Dimensions
Appliance dimensions Safety distance between hob and cooker hood The minimum safety distances between the top of a cooker or hob and the bottom of the cooker hood are as follows, unless a greater distance is specified by the manufacturer of your cooking appliance: 550 mm above electric hobs and... -
Page 23: Installation
Installation Before installation, it is important to read the information given on the 4 screws M4 x 8 mm following pages as well as the for securing the towers. "Appliance dimensions" and the "Warning and Safety instructions" at the beginning of this booklet. This is particularly crucial when using the cooker hood at the same 8 spacers... -
Page 24: Connection For Air Extraction
Connection for air extraction – Where ducting is horizontal, it must Important: To avoid the danger of be laid to slope away at at least 1 cm toxic fumes, please observe the per metre. Warning and Safety instructions. This is to ensure that condensate This is especially crucial when using cannot drain back into the cooker the cooker hood at the same time as... -
Page 25: Condensate Trap
Connection for air extraction Important! If the exhaust ducting is to run through rooms, ceiling space etc. where there may be great variations in temperature between the different areas, the problem of condensation will need to be addressed. The exhaust ducting will need to be suitably insulated. -
Page 26: Electrical Connection
Electrical connection If these switches are not accessible All electrical work should be after installation (depending on undertaken by a suitably qualified country), an additional means of and competent person in strict disconnection must be provided for all accordance with current national poles. -
Page 27: Operation With Control Module Dsm 400
Operation with Control module DSM 400 The Miele DSM 400 control module can If the control modules are be used to combine the cooker hood disconnected in order to operate the with other components. cooker hood without the window As the right and left hand sides of the contact switch (e.g. -
Page 28: Connection To A Light Switch
Operation with Control module DSM 400 Connection to a light switch The control modules can be used to switch on the cooker hood lighting and also to dim it, depending on model, via a light switch in the house. Installation The cover plates securing the towers to the ceiling need to be removed before the control modules can be fitted into... -
Page 29: After Sales Service
In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer – The Miele Service Department (see back cover for address). When contacting your Dealer or the Service Department, please quote the model and serial number of your appliance. -
Page 30: Technical Data
Technical data Total connected load ..520 W – Fan motors ... . . 2 x 200 W – Hob lighting ... . . 6 x 20 W Voltage . - Page 32 Alteration rights reserved / 1307 M.-Nr. 07 054 700 / 00 en - GB...