Page 1
Operating and installation instructions Cooker hood To prevent the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. en-GB M.-Nr. 11 467 720...
Contents Warning and Safety instructions................ 3 Caring for the environment ................ 12 Modes of operation ..................... 13 Guide to the appliance .................. 14 Operation...................... 16 Switching the fan on....................16 Selecting the power level ..................16 Run-on time......................16 Switching the fan off ..................... 16 Switching the hob lighting on/off ................
Miele cannot be held liable for injury or damage caused by non- compliance with these instructions. Keep these instructions in a safe place and pass them on to any future owner.
Page 4
Warning and Safety instructions The cooker hood can only be used by people with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if they are supervised whilst using it, or have been shown how to use it in a safe way and recognise and understand the consequences of incorrect operation.
Page 5
Unauthorised installation, maintenance and repairs can cause considerable danger for the user. Installation, maintenance and repairs must only be carried out by a Miele authorised technician. A damaged appliance can be dangerous. Check it for visible signs of damage. Do not use a damaged appliance.
Page 6
Miele spare parts. If the electrical connection cable is faulty it must only be replaced by a Miele authorised service technician to protect the user from danger. During installation, maintenance and repair work, the appliance...
Page 7
Warning and Safety instructions Using at the same time as another heating appliance that depends on the air from the room Danger of toxic fumes! Great care should be taken when using the cooker hood in the same room or the same area of the house at the same time as another heating appliance that depends on the air from the room.
Page 8
Warning and Safety instructions In order to ensure safe operation and to prevent gases given off by the heating appliance from being drawn back into the room when the cooker hood and the heater are both operated simultaneously, an underpressure in the room of 0.04 mbar (4 Pa) is the maximum permissible.
Page 9
Warning and Safety instructions Correct use Open flames are a fire hazard. The use of an open flame under the cooker hood is not permitted. To avoid the danger of fire, do not flambé or grill over an open flame. When switched on, the cooker hood could draw flames into the filter.
Page 10
Wear gloves to protect your hands from being cut. Exhaust ducting must be of non-inflammable material. Suitable material is available from Miele specialist dealers or the Miele Spares Dept. The appliance must not be connected to a chimney or flue which is in use.
Page 11
The steam could reach electrical components and cause a short circuit. Accessories Only use genuine original Miele accessories and spare parts with this appliance. Using accessories or spare parts from other manufacturers will invalidate the warranty and Miele cannot accept liability.
Please dispose of it at your local community waste collection / recycling centre for electrical and electronic appliances, or contact your dealer or Miele for advice. You are also responsible for deleting any personal data that may be stored on the appliance being disposed of. Please...
Modes of operation Depending on the model of the cooker Recirculation mode hood, the following options are Recirculation mode cooker hoods available: require a conversion kit and charcoal filters (see “Technical Data”) Extraction mode The air is drawn in and cleaned first by The air is drawn in and cleaned by the the grease filters and then by the grease filters and directed outside.
Page 15
Hob lighting c Charcoal filters (x 2) Accessories required for recirculation mode d Grease filters (DA 2360: 1 filter; DA 2390: 2 filters) e Controls f On/Off control for the fan g Controls for setting the fan power level...
Operation Switching the fan on Switching the hob lighting on/ Switch the fan on as soon as you start cooking. This is to ensure that vapours The hob lighting can be switched on are captured right from the start. and off independently of the fan. ...
Operation Switching Power management on/off Safety switch-off You can deactivate Power If Power management has been management. deactivated, the cooker hood will This can result in increased electricity switch itself off automatically after consumption. 12 hours if it has been left on (fan and hob lighting).
Energy saving tips This cooker hood operates very efficiently and economically. The following will help you to save even more energy when using it: – Ensure that there is sufficient ventilation in the kitchen when cooking. In extraction mode, if there is insufficient air flow the cooker hood cannot operate efficiently and this causes increased operating noise...
Unsuitable cleaning agents can becoming dirty again, we recommend damage the surfaces and control treating them with a stainless steel care elements. product (available from Miele). Do not use any cleaning agents containing soda, acid, chloride or Important information for the control solvent.
Cleaning and care Grease filters Fire hazard Oversaturated grease filters are a fire hazard. Clean the grease filters at regular intervals. The re-usable metal grease filters in the appliance remove solid particles (grease, dust, etc.) from the kitchen vapours, preventing soiling of the ...
Page 21
Cleaning and care Cleaning the grease filters in the dishwasher Place the grease filters upright or slightly inclined in the lower basket. Ensure the spray arm is not obstructed. Use a commercially available household dishwasher detergent. If a grease filter is inadvertently ...
The charcoal filters are fitted in the canopy above the grease filters. Charcoal filters are available to order via the Miele online shop, the Miele Customer Service Department (see end of these operating instructions for contact details) or from your Miele dealer.
Only use lamps of the same type in the Grip the lamp, turn it anti-clockwise cooker hood. and take it out. These lamps are available from Miele or Screw the new lamp into the socket from specialist retailers. and push it upwards. Please follow...
*INSTALLATION* Installation Before installation Before installation, it is important to read the information given on the following pages as well as the “Warning and Safety instructions” at the beginning of this booklet. The cooker hood is intended for installation in a wall unit, chimney unit 4 M5 x 40 mm screws, 4 washers, or above breakfast bars or island areas.
Page 25
*INSTALLATION* Installation Keep the following in a safe place: Installation plan See the installation plan for details on the individual steps involved in the installation of this appliance. 1 lever for removing lamps.
*INSTALLATION* Installation a Alternative vent connection at the back. b The cooker hood is fastened in the cut-out using clamps. A solid installation surface, e.g. made of wood, is required. Make sure that the structure can support the load. Around the clamps, components such as supports and ducting must be at least 25 mm from the cut-out.
*INSTALLATION* Installation Installation recommendations Uneven installation surfaces – Please be aware that if positioned too high, extraction will be inefficient. – To achieve optimum vapour extraction, the cooker hood must be centred over the hob, not to the side or behind it. If the installation surface is uneven –...
*INSTALLATION* Installation Connection for air extraction If the cooker hood is used at the same time as a heating appliance that relies on oxygen from the same room, there is a risk in certain circumstances of toxic fumes building up. It is essential that the “Warning and Safety”...
*INSTALLATION* Installation If the exhaust is ducted through an Silencer outside wall, a telescopic wall vent or a roof vent (available as an optional accessory) is recommended. If the exhaust air is to be ducted into To achieve even further reductions in a flue, the ducting must be directed in noise levels, a special silencer (optional the flow direction of the flue.
*INSTALLATION* Installation Recirculation mode Electrical connection This cooker hood is supplied for connection to an AC 230 V ~ 50 Hz supply. It must be connected to an earthed socket which complies with relevant regulations. The electrical installation must comply with VDE 0100 requirements (BS 7671 in the UK).
Service Contact in case of malfunction In the event of any faults which you cannot remedy yourself, please contact your Miele Dealer or Miele Service. Contact information for Miele Service can be found at the end of this document. Please note that telephone calls may be...
Technical data Fan motor 220 W Hob lighting DA 2360 2 x 3 W DA 2390 4 x 3 W Total rated load DA 2360 226 W DA 2390 232 W Mains voltage, frequency AC 230 V, 50 Hz Fuse rating 3 A Mains connection cable length 1.5 m Weight DA 2360 11 kg DA 2390 13 kg Optional accessories for recirculation mode DUU 150 or DUU 151 conversion kit and DKF 19-1 charcoal filter set.
Page 34
Technical data Data sheet for household cooker hoods In acc. with delegated regulation (EU) No. 65/2014 and regulation (EU) No. 66/2014 MIELE Model name / identifier DA 2360 Annual Energy Consumption (AEC 49,1 kWh/year hood Energy efficiency class Energy efficiency index (EEI...
Page 35
Technical data Data sheet for household cooker hoods In acc. with delegated regulation (EU) No. 65/2014 and regulation (EU) No. 66/2014 MIELE Model name / identifier DA 2390 Annual Energy Consumption (AEC 55,3 kWh/year hood Energy efficiency class Energy efficiency index (EEI...