Page 1
Operating and installation instructions Cooker hood To prevent the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. en-GB M.-Nr. 11 468 290...
Contents Warning and Safety instructions................ 4 Caring for the environment ................ 13 Modes of operation ..................... 14 Con@ctivity 2.0 function..................15 Guide to the appliance .................. 16 Operation (Automatic mode) ................ 18 Cooking with Con@ctivity 2.0 (Automatic mode) ..........18 Cooking process ....................
Page 3
Contents Remote control...................... 32 Cleaning the remote control ................32 Changing the battery..................32 Installation...................... 33 Before installation....................33 Installation instructions..................33 Appliance dimensions ................... 34 Safety distance between hob and cooker hood (S) ..........36 Installation recommendations ................37 Connection for air extraction .................
Miele cannot be held liable for injury or damage caused by non- compliance with these instructions. Keep these instructions in a safe place and pass them on to any future owner.
Page 5
Warning and Safety instructions The cooker hood can only be used by people with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if they are supervised whilst using it, or have been shown how to use it in a safe way and recognise and understand the consequences of incorrect operation.
Page 6
Unauthorised installation, maintenance and repairs can cause considerable danger for the user. Installation, maintenance and repairs must only be carried out by a Miele authorised technician. A damaged appliance can be dangerous. Check it for visible signs of damage. Do not use a damaged appliance.
Page 7
The manufacturer's warranty will be invalidated if the appliance is not repaired by a Miele approved service technician. Miele can only guarantee the safety of the appliance when genuine original Miele replacement parts are used. Faulty components must only be replaced by Miele spare parts.
Page 8
Warning and Safety instructions Using at the same time as another heating appliance that depends on the air from the room Danger of toxic fumes! Great care should be taken when using the cooker hood in the same room or the same area of the house at the same time as another heating appliance that depends on the air from the room.
Page 9
Warning and Safety instructions In order to ensure safe operation and to prevent gases given off by the heating appliance from being drawn back into the room when the cooker hood and the heater are both operated simultaneously, an underpressure in the room of 0.04 mbar (4 Pa) is the maximum permissible.
Page 10
Warning and Safety instructions Correct use Open flames are a fire hazard. The use of an open flame under the cooker hood is not permitted. To avoid the danger of fire, do not flambé or grill over an open flame. When switched on, the cooker hood could draw flames into the filter.
Page 11
Wear gloves to protect your hands from being cut. Exhaust ducting must be of non-inflammable material. Suitable material is available from Miele specialist dealers or the Miele Spares Dept. The appliance must not be connected to a chimney or flue which is in use.
Page 12
Please dispose of them in a designated battery collection and recycling system. Accessories Only use genuine original Miele accessories and spare parts with this appliance. Using accessories or spare parts from other manufacturers will invalidate the warranty and Miele cannot accept liability.
Old batteries and rechargeable batteries appliances, or contact your dealer or contain important raw materials which Miele for advice. You are also can be recycled. Disposing of batteries responsible for deleting any personal and rechargeable batteries separately...
The flap is closed when the cooker a Miele external motor located in a hood is switched off. position of your choice outside the When the cooker hood is switched on, room.
Modes of operation The hob transmits information about its Con@ctivity 2.0 function operational status via a wireless signal Automatic control to the cooker hood. The cooker hood has a communication – When the hob is switched on, the facility which enables the automatic hob lighting comes on independently operation of the cooker hood and then after a short time the fan...
Page 17
Guide to the appliance a Edge extraction panels Optional accessories DRP 2900 Glass (4 panels) DRP 2900 Stainless steel (4 panels) b Hob lighting c Controls d Grease filters e Indicator light f Hob lighting control g Controls to select the fan power level The controls on the remote control are also used to switch the fan on and off.
Operation (Automatic mode) When Con@ctivity 2.0 is activated, the Reaction time cooker hood always works in automatic The cooker hood reacts with a slight mode (see “Activating Con@ctivity 2.0”). delay because altering the power level To operate the cooker hood manually, on the hob does not immediately result see “Cooking without Con@ctivity 2.0”.
Operation (Automatic mode) Cooking process Switching off For example, you switch on a cooking Switch off all cooking zones. zone at the highest power level to The cooker hood fan will reduce its heat a pan for frying. You reduce the power level in stages over the next few power level after approx.
Operation (Automatic mode) You can also operate the cooker hood Leaving automatic mode manually for a complete cooking temporarily process. To leave automatic mode temporarily Switch the cooker hood fan on during cooking: before the hob. Manually select a different fan power If the cooker hood fan and the hob have level, or been switched off for at least...
Operation (Manual mode) Cooking without Con@ctivity Switching the fan on 2.0 (Manual mode) Switch the fan on as soon as you start cooking. This is to ensure that vapours The cooker hood can be operated are captured right from the start. manually if: ...
Operation (Manual mode) Selecting the run-on time Switching the hob lighting on/ It is advisable to run the fan for a few minutes after cooking has finished. This The hob lighting can be switched on helps to remove any lingering vapours and off independently of the fan.
Operation (Manual mode) Activating/deactivating Power Safety switch-off Management If Power management has been Switch off the fan and the lighting. deactivated, the cooker hood will switch itself off automatically after Press the fan run-on control for 12 hours if it has been left on (fan and approx.
Operation (Automatic and Manual modes) The Grease filter symbol and one of Operating hours counter the fan power level indicators will flash. The cooker hood registers the length of Fan power level indicators 1 to B show time it has been operated. the time set: When the grease filter symbol ...
Operation (Automatic and Manual modes) Activating and altering the charcoal Reading the filter operating hours filter operating hours counter counter Charcoal filters are needed for You can check the percentage of time recirculation mode. set already used before the filter needs replacing.
Energy saving tips This cooker hood operates very – Use the Con@ctivity function. The efficiently and economically. The cooker hood will switch on and off following will help you to save even automatically at the optimum power more energy when using it: level for the cooking you are doing, which ensures low energy –...
Cleaning and care Housing Before proceeding with any maintenance or cleaning task, the General information cooker hood must be disconnected from the power supply (see “Warning Unsuitable cleaning agents can and Safety instructions”). damage the surfaces and control elements. Do not use any cleaning agents containing soda, acid, chloride or solvent.
Heavily soiled grease filters hinder air product (available from Miele). extraction and will lead to increased levels of soiling in the cooker hood Important information for the control and in the kitchen.
Page 29
Cleaning and care Removing the panels and grease filters The panels and the grease filters need to be removed for cleaning. During cooking, condensation forms on the panels which evaporates after cooking. To avoid this dripping on you, do not remove the panels for approximately two hours after cooking has finished.
Page 30
Cleaning and care If a grease filter is inadvertently Cleaning the panels and grease filters in the dishwasher replaced upside down, insert a small screwdriver blade into the slit to Place the panels and grease filters disengage the clip. upright or slightly inclined in the lower basket.
Cleaning and care The charcoal filter operating hours Resetting the grease filter operating hours counter counter needs to be activated before using for the first time (see After cleaning, the operating hours “Operation”). counter needs to be reset. Resetting the charcoal filter ...
Cleaning and care Remove the old battery and replace Remote control with a new one. Make sure the Cleaning the remote control polarity is correct. Only clean the surface with a damp Refit the cover and secure with the cloth.
Installation Before installation Before installation, it is important to read the information given on the following pages as well as the “Warning and Safety instructions” at the beginning of this booklet. Installation instructions See enclosed Installation sheet for instructions on how to install this appliance.
Page 35
Installation a Suction side b Motor can be rotated. Exhaust socket can be fitted at the top or the sides in any direction. c The motor unit can be freely positioned. Connection to the appliance is via the exhaust ducting and the connection cable. Connection cable length: max. 1800 mm.
Installation Safety distance between hob and cooker hood (S) When planning the installation height of your cooker hood, the minimum safety distance between the top of a cooker or hob and the bottom of the cooker hood is as follows, unless a greater distance is specified by the manufacturer of your cooking appliance.
Installation Installation recommendations Connection for air extraction – We recommend a minimum distance If the cooker hood is used at the of 700 mm and a maximum distance same time as a heating appliance of 1300 mm. that relies on oxygen from the same room, there is a risk in certain –...
Installation – The exhaust ducting must not be Silencer kinked or compressed. – Ensure that all connections are strong and airtight. Remember that any constriction of the air flow will reduce extraction performance and increase operating noise. If the exhaust is ducted through an outside wall, a telescopic wall vent or a roof vent (available as an optional To achieve even further reductions in...
Installation Extraction mode with external motor For increased safety, VDE recommends in its guideline DIN VDE 0100, Part 739 to use a residual current device with a trip current of 30 mA (DIN VDE 0664). A suitable means of disconnection must be provided on site for each pole. Suitable means of disconnection include switches with an all-pole contact gap of at least 3 mm.
Activating Con@ctivity 2.0 Activating the cooker hood Installing the Con@ctivity 2.0 Stick This is only possible via the cooker hood control panel, not via the In order to use the Con@ctivity 2.0 remote control. function, the hob must first be fitted with the Con@ctivity 2.0 Stick.
Activating Con@ctivity 2.0 Activating the hob Activation failed While the cooker hood is searching If the wireless connection cannot be for a signal, start activating the hob. established despite activating the More information about this can be cooker hood and the hob, both found in the Operating instructions appliances must first be deactivated for the hob.
Signing on/off the remote control If the connection has been lost between Signing on and off must be done at the the remote control and the cooker same time on the cooker hood and the hood, they must be signed on again. To remote control.
Page 43
Signing on/off the remote control Confirm the signing off procedure by pressing the run-on option control 515 on the cooker hood. All indicators will go out. Please bear in mind that disabling the signal will also disable any Con@ctivity 2.0 function and this will have to be activated again.
Miele dealer or the Miele Service Department. Contact details for Miele are given at the end of this booklet. N.B. A call-out fee will be charged for service visits where the problem could have been resolved as described in these instructions.
Maximum transmission power 10 mW Conformity declaration Miele hereby declares that this cooker hood complies with Directive 2014/53/EU. The complete text of the EU declaration of conformity is available from one of the following internet addresses: – Products, Download from www.miele.co.uk –...
Page 46
Technical data Data sheet for household cooker hoods In acc. with delegated regulation (EU) No. 65/2014 and regulation (EU) No. 66/2014 MIELE Model name / identifier DA 2906 Annual Energy Consumption (AEC 36,1 kWh/year hood Energy efficiency class Energy efficiency index (EEI...
Page 47
Power consumption in standby mode (P 0,15 W Nominal power of lighting system 12,0 W Average illumination of the lighting system on the cooking surface 450 Ix Time increase factor The above values were determined in combination with the Miele ABLG 202 external motor.