Communications - GE D60 Instruction Manual
Line distance protection system, ur series
Hide thumbs
Also See for D60:
- Instruction manual (826 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (822 pages)
Table of Contents
Advertisement
5.2 PRODUCT SETUP
a) MAIN MENU
PATH: SETTINGS
PRODUCT SETUP
COMMUNICATIONS
5
b) SERIAL PORTS
PATH: SETTINGS
PRODUCT SETUP
SERIAL PORTS
The D60 is equipped with up to two independent serial communication ports. The faceplate RS232 port is intended for local
use and is fixed at 19200 baud and no parity. The rear COM2 port is RS485. The RS485 port has settings for baud rate and
parity. It is important that these parameters agree with the settings used on the computer or other equipment that is con-
nected to these ports. Any of these ports can be connected to a computer running EnerVista UR Setup. This software can
download and upload setting files, view measured parameters, and upgrade the relay firmware. A maximum of 32 relays
can be daisy-chained and connected to a DCS, PLC, or computer using the RS485 ports.
For the RS485 port, the minimum time before the port transmits after receiving data from a host can be set. This
feature allows operation with hosts which hold the RS485 transmitter active for some time after each transmission.
NOTE
c) ETHERNET NETWORK TOPOLOGY
When using more than one Ethernet port, configure each to belong to a different network or subnet using the IP addresses
and mask, else communication becomes unpredictable when more than one port is configured to the same subnet.
5-26
COMMUNICATIONS
SERIAL PORTS
NETWORK
MESSAGE
ROUTING
MESSAGE
MODBUS PROTOCOL
MESSAGE
DNP PROTOCOL
MESSAGE
DNP / IEC104
MESSAGE
POINT LISTS
IEC 61850 PROTOCOL
MESSAGE
WEB SERVER
MESSAGE
HTTP PROTOCOL
TFTP PROTOCOL
MESSAGE
IEC 60870-5-104
MESSAGE
PROTOCOL
COMMUNICATIONS
RS485 COM2 BAUD
RATE: 19200
RS485 COM2 PARITY:
MESSAGE
None
RS485 COM2 RESPONSE
MESSAGE
MIN TIME:
D60 Line Distance Protection System
See below.
See page 5–29.
See page 5–31.
See page 5–34.
See page 5–34.
See page 5–37.
See page 5–38.
See page 5–53.
See page 5–53.
See page 5–54.
SERIAL PORTS
Range: 300, 1200, 2400, 4800, 9600, 14400, 19200,
28800, 33600, 38400, 57600, 115200
Range: None, Odd, Even
Range: 0 to 1000 ms in steps of 10
0 ms
5 SETTINGS
5.2.4 COMMUNICATIONS
GE Multilin
- Quick Links:
- Power Supply
Hide quick links:
Advertisement
Table of Contents
