Table of Contents
Advertisement
DS484Q/DS486Q | Installation Instructions | 5.0
5.0 Walk Test
Walk across the beam path directly in front of one of the detectors. The ALARM LED should activate. If not, the
beam interrupt time is set too low or the alignment is not correct.
Walk across the beam path in several locations between the detectors (Figure 24).Each time you cross the beam
path, the ALARM LED should activate. If not, the beam interrupt time is set too low or the alignment is not
correct.
Figure 24: Walk Test Pattern
1
1 - Receiver
2 - Transmitter
Inspect the system and perform a walk test at least once a year.
16
4
Walk Test
3
3 - Beam path
4 - Crossing the beam path
Bosch Security Systems, Inc. | 7/05 | 4998138530F
2
- Quick Links:
- Installation
- Setup and Alignment
Hide quick links:
Advertisement
Table of Contents
