Table of Contents
Advertisement
42
en | Installing a Recessed Mount
12. Snap trim ring into place. Ensure snaps are secure by
13. Use the supplied T-10 Torx wrench to secure the trim
F.01U.172.910 | 4.0 | 2011.09
Note: The two (2) sets of raised stand-off tabs (item 4) on
each side of the trim ring align with the locking clamps.
Figure 6.8 Align Trim Ring
1
Alignment Tabs (four)
2
Align tabs to the recessed areas on the housing
3
Align safety locking screws to these connections
4
Stand-off Tabs (two)
attempting to lightly turn unit. Note: Unit should not turn.
ring's two (2) safety locking screws to the mounting
bracket.
Installation Manual
AutoDome Junior HD
Bosch Security Systems, Inc.
Advertisement
Table of Contents
