Table of Contents
1
Safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
2
2.1
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
3
Technical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
4
5
6
6 720 876 028 (2020/10)
1
Safety information
This appliance is intended for domestic use and the
household environment only.
Please read this installation instruction manual
carefully, then act accor dingly! Store for future
reference. These installation instructions must be
included when transferring this appliance to a new
owner.
• The appliance may only be connected and put
into operation by a qualified professional.
• Install and operate the appliance as described in
the text and illustrations. We do not accept liability
for damage resulting from failure to heed these
instructions.
• The supplied water connection nozzles must be
used and installed as shown in the supplementary
sheets. Make sure that a check valve is installed in
the cold water supply line.
• This appliance is intended for use up to an altitude
of 2,000 m above sea level.
• The appliance may only be installed and stored in a
frost-free room (due to residual water).
WARNING:
Risk of electric shock!
Switch off the mains voltage supply immediately if a
fault occurs.
Disconnect the power supply before opening the
appliance.
Immediately shut off the cold water supply to the
appliance should it leak.
These installation instructions are intended for
plumbers, heating engineers and electricians. All
instructions must be observed. Failure to comply with
instructions may result in material damage and
personal injury, including possible loss of life.
▶ Read the installation instructions (heat source,
heating controller, etc.) before installation (
chapter 2).
▶ Observe the safety instructions and warnings.
▶ Observe national and regional regulations,
technical rules and guidelines.
• The statutory regulations of the respective country,
as well as those of the local electricity and water
suppliers, must be adhered to.
• The continuous-flow heater is a Class I appliance
and must be connected to the protective earth.
Table of Contents
7