Table of Contents
Advertisement
D8125MUX | Operation and Installation Guide | 3.0
3.2
Programming
3.2.1
Powering the D5060
Turn on the D5060 by pressing and holding the [1]
key until the unit beeps. To turn the unit off, press and
hold the [#] and [*] keys simultaneously until the unit
beeps.
After 5 minutes of inactivity, the
programmer powers down automatically
to conserve power.
3.2.2
Programming Points
1. The D5060 shows the prompt Adr after it is
powered. This indicates that it is ready to begin
programming.
2. If the multiplex device has no DIP switches,
connect the D5060 to the point to be programmed
as shown in Figure 3 on page 5. If the mutiplex
device has DIP switches, program the device
using its DIP switches.
If the mutiplex device has no DIP
switches, connect the D8125MUX and
the mutiplex device to be programmed to
the D5060 for simultaneous programming
(Figure 3). If the mutiplex device has DIP
switches, program the device using its
DIP switches, and program the
D8125MUX using the D5060 (Figure 4 on
page 5).
3. Enter the point's three-digit address. The address
must be between 1 and 255. Press [#].
The programmer shows tyP.
4. Enter the number corresponding to the point type
you are programming as shown in Table 3 and
press [#]. The programmer alternately shows the
address and the point type.
When you program for a mutiplex smoke
device by entering decimal value 4 or 5
Table 3, an 18-second timer starts
counting. Do not disconnect the mutiplex
smoke device until after the timer counts
down to zero.
6
Installation
Table 3:
Point Type Entry Code
Decimal
Point Type
Value
0
Remove point from D8125MUX
1
Contact
2
Sensor (or single point module)
3
I/O module
4
Multiplex smoke without low temperature
5
Multiplex smoke with low temperature (0°C)
6
Dual point
5. Press [#] to program a point connected to the
D5060 and the D8125MUX (if connected), or
press [1] to program the D8125MUX only. If the
mutiplex device has DIP switches, program the
device using its DIP switches.
Press [*] at any time to return to a
previous step in the procedure.
6. If the point is programmed correctly, the unit
beeps once and shows Adr, indicating it is ready
to program the next point. If the point was not
programmed correctly, the unit sounds a three-
beep error tone and one of the following
messages appears:
Err: The point was not programmed correctly.
PnL: Communications with the D8125MUX
failed.
7. Press [*] to clear the entry, or press [#] to
reprogram.
If programming the D8125MUX and multiplex
device simultaneously and only one receives the
program, the D5060 shows Adr. If having
troubles with the point after installation, try
programming the D8125MUX and multiplex
devices separately.
3.2.3
Removing a Point from the D8125MUX
1. Apply power to the D5060 and connect the
programmer to the D8125MUX only.
2. Enter the address of the point you want to
remove.
3. When prompted for a point type, press [0]. Refer
to Table 3. Then press [#].
4. Press [1] to remove the point.
5. If the point is programmed correctly, the D5060
beeps once and Adr appears.
Bosch Security Systems, Inc. | 10/09 | F01U034973-02
Advertisement
Table of Contents
