Table of Contents
Advertisement
3.5.1.1 During a normal boot, you may observe
1.
Power is distributed to peripherals, control console, monitor, FrontEnd and BackEnd processor.
2.
The BackEnd processor and rest of the system starts with the sequence listed in following steps:
a.
First of all, the BIOS version is shown on the monitor.
b.
Afterward the "Boot Screen" is displayed. (Voluson is highlighted).
3.
BackEnd processor is turned ON and starts to load the software.
4.
The start screen is displayed on the monitor.
5.
Start-up progress bars indicating software loading procedures, are displayed on the monitor.
6.
The software initiates and sets up the FrontEnd electronics and the rest of the system (incl. clicking
sound of relays on RTF board).
7.
The keyboard backlight is lit.
8.
As soon as the software has been loaded, the 2D screen is displayed on the monitor.
Voluson E-Series Service Manual
KTD106657 Revision 2
Figure 3-31 Boot screen
Figure 3-32 start-up screen
Setup Instructions
3-41
Advertisement
Chapters
Table of Contents
Troubleshooting
