GE F650 Instruction Manual page 478

Digital bay controller

Hide thumbs Also See for F650:

Table of Contents

9 BOOTCODE AND FIRMWARE UPGRADE

If when click on Upgrade Firmware button (Figure 9–24:) an advise message is given (Figure 9–25:), local network

reboot is necessary. Then please proceed as follows:

STARTUP>CONTROL

key>Disable. Now the Local Network status will be shown as Disabled.In the same screen with Right mouse key

over LOCAL NETWORK click Enable and wait until Enabled status is shown. Then press Upgrade Firmware button

to continue the process (Figure 9–24:).

When upgrading models with Enhanced protection or control functionality (see model selection), the program will

request a password to continue (Figure 9–26:)

Figure 9–26: PASSWORD REQUIREMENT (SPECIAL MODELS)

In case special functionality model with password requirement please contact GE Multilin.

The following parameters must be clearly indicated in the order:

Unit serial number

Current model option (before memory upgrade)

Desired model option (after memory upgrade)

Unit MAC address (available in the identification label)

Once the upgrade parameters have been entered, press the "Upgrade Firmware" button. When communication has

been established, the program will show a message requesting to turn OFF and back ON the relay to continue with the

upgrade process.(Figure 9–30:)

GEK-106310AB

PANEL>NETWORK

CONNECTION>LOCAL

F650 Digital Bay Controller

9.3 FIRMWARE VERSION UPGRADE