Miele DA 428-4 EXT Operating And Installation Instructions
Hide thumbs
Also See for DA 428-4 EXT:
- Operating and installation manual (40 pages) ,
- Operating and installation manual (40 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Miele DA 428-4 EXT
Summary of Contents for Miele DA 428-4 EXT
- Page 1 Operating and installation instructions Cooker hood DA 428-4, DA 428-4 EXT DA 429-4, DA 429-4 EXT en - GB, AU, NZ To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time.
-
Page 2: Table Of Contents
Miele|home ........ - Page 3 Contents Operation with Control module DSM 400 ......35 Connection to a window contact switch ......35 Potential free connection .
-
Page 4: Caring For The Environment
Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. -
Page 5: Warning And Safety Instructions
Any other usage is not supported by This appliance complies with all the manufacturer and could be relevant local and national safety dangerous. Miele cannot be held liable requirements. Inappropriate use for damage resulting from incorrect or can, however, lead to personal injury improper use or operation of the and damage to property. -
Page 6: Technical Safety
Technical safety Installation, maintenance and repairs may only be carried out by a Before installation, check the cooker Miele authorised person in strict hood for visible signs of damage. accordance with current national and Under no circumstances should you local safety regulations. - Page 7 These models may only be combined with a Miele external motor. This appliance may only be used in mobile installations if a risk assessment of the installation has been carried out by a suitably qualified engineer.
- Page 8 The Miele DSM 400 control module appliance is switched off or vice versa. offers the possibility of combining other A ventilation brick alone is not generally components with the cooker hood (see sufficient to ensure safe ventilation.
-
Page 9: Correct Use
Warning and safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé... -
Page 10: Correct Installation
Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use. -
Page 11: Modes Of Operation
Modes of operation . . . air recirculation: The cooker hood works with (available as an optional extra with a conversion kit and charcoal filter: see "Technical Data") . . . air extraction: The air is drawn in and cleaned by the The air is drawn in and cleaned first by grease filters and directed outside. -
Page 12: Guide To The Appliance
Guide to the appliance... - Page 13 Guide to the appliance a Telescopic extension piece m Touch control for grease filters b Tower The indicator lamp for the grease filters lights up when the grease filters need c Canopy to be cleaned. d Control panel The touch control is used to reset the e Grease filters operating hours counter every time the grease filters are cleaned (see...
-
Page 14: Miele|Home
Miele electric hob with onset controls. This module must be installed by a Miele service technician or suitably For communication to take place, the qualified electrician. -
Page 15: Operation
Operation To switch the fan on Automatic switch-off of the Intensive setting You can set the Intensive setting so that it only runs for 10 minutes before reverting automatically to level III. ^ Press the On/Off touch control. ^ To set this option, both the fan and The fan runs at power level "II". -
Page 16: Run-On Option
Operation Run-on option It is advisable to run the fan for a few minutes after cooking is finished to neutralise any lingering odours in the The indicator lamps for fan power levels air, whether you are using air extraction I and IV will flash if the automatic or recirculation mode. -
Page 17: To Switch The Hob Lighting On
Operation To switch the hob lighting on Safety cut-out The hob lighting can be switched on Should the cooker hood be left on, the and off independently of the fan. fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the lighting control to switch on the hob lighting. - Page 18 Operation Reading the operating hours counter Altering the operating hours counter for the grease filters for the grease filters To check the percentage of time set The operating hours counter for the already used: grease filters is set at 30 hours. This can be lengthened or shortened to suit the type of cooking you do.
- Page 19 Operation Activating and altering the operating hours counter for the charcoal filter (in recirculation mode) The charcoal filter is needed for The – / + control lamps show the time recirculation mode. which has been set: 1st lamp from the left = 20 hours On delivery, the operating hours counter 2nd lamp from the left = 30 hours for the charcoal filter is switched off,...
- Page 20 Operation ^ Use the – / + controls to select the Reading the operating hours counter desired time. for the charcoal filter To check the percentage of time set already used: ^ Confirm the selection by pressing the charcoal filter touch control. All the indicator lamps will go out.
-
Page 21: Cleaning And Care
– the screw-out fuse is removed (in countries where this is applicable). Important for appliances with A range of Miele branded cleaning and stainless steel housing conditioning agents are available to (This infomation does not apply to the order through your Miele Dealer / controls). -
Page 22: Grease Filters
Cleaning and care Grease filters Important for appliances with special finish The re-usable metal grease filters in the (Titanium and special order finishes) appliance remove solid particles (grease, dust, etc.) from the kitchen Please follow the information given in vapours, preventing soiling of the “General notes"... - Page 23 65°C programme, ensuring the spray ^ After replacing the grease filters, arm is not obstructed. If a Miele press the grease filter touch control dishwasher is being used, select the for approximately 3 seconds to re-set Sensor wash programme.
-
Page 24: Fitting And Replacing The Charcoal Filter
New filters can be purchased from – if it is no longer effective in absorbing your Miele Dealer / Chartered Agent kitchen odours. or from the Miele Spare Parts It should, however, be replaced at least Department. -
Page 25: Changing A Halogen Lamp
Cleaning and care Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that: – it is switched off at the isolator, or – it is switched off at the wall socket and the plug is withdrawn, or –... -
Page 26: Appliance Dimensions
Appliance dimensions 1) Extraction 2) Recirculation 3) Ventilation grille positioned at the top for recirculation 4) and 5): (5 is not required for recirculation mode cooker hoods) The shaded area represents the wall or ceiling area for the vent cut-out, for fitting the connection socket and on EXT models for feeding the connection cable through to the external motor. -
Page 27: Safety Distance (S)
If this cooker hood is installed above when planning the installation height a Miele Wok CS 1028 CombiSet of the cooker hood. appliance, a minimum safety distance of 760 mm must be maintained between the burner and the lower edge of the cooker hood. -
Page 28: Installation
Installation Assembly parts... - Page 29 Installation a 3 protective sheets for use when fitting the tower. b 1 exhaust connection for exhaust 6 screws 5 x 40 mm and ducting C 150 mm. 6 x S 8 plugs c 1 reducing collar for securing the wall bracket. for exhaust ducting C 125 mm.
-
Page 30: Installation Instructions
Installation Dismantling Before installation, it is important to Should the appliance ever need to be read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as "Appliance dimensions" and the described on the installation sheet. -
Page 31: Connection For Air Extraction
Connection for air extraction – Only use smooth pipes or flexible Important: To avoid the danger of hoses made from non-flammable toxic fumes, please observe the materials for the extraction ducting. Warning and Safety instructions. – When using an external motor, make This is especially crucial when using sure that the exhaust ducting is the cooker hood at the same time as... -
Page 32: Condensate Trap
Connection for air extraction Condensate trap – If the exhaust air is to be ducted into the open air, the installation of a (optional accessory) telescopic wall vent or roof vent (available as an optional accessory) is recommended. – If the exhaust air is to be ducted into a vent flue, the ducting must be directed in the flow direction of the flue. -
Page 33: Silencer
Connection for air extraction Silencer ...with air extraction: (optional accessory) The silencer not only reduces noise from the motor outside the house, but also sounds from outside (e.g. traffic noise). For this reason the silencer must be positioned as close as possible to the ducting exit a. -
Page 34: Electrical Connection
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to protect and local safety regulations the appliance with a suitable residual... -
Page 35: Operation With Control Module Dsm 400
Operation with Control module DSM 400 The Miele DSM 400 Control module can If the control module is disconnected be used to combine the cooker hood in order to operate the cooker hood with other components. without the window contact switch It enables the following: (e.g. -
Page 36: Connection To A Light Switch
Operation with Control module DSM 400 Connection to a light switch The control module can be used to switch on the cooker hood lighting and also to dim it, depending on model, via a light switch in the house. Installation The tower needs to be removed before the control module can be fitted to the fan unit. -
Page 37: After Sales Service
In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer / Chartered Agent – The Miele Service Department (see back cover for address). When contacting your Dealer or Miele, please quote the model and serial number of your appliance. -
Page 38: Technical Data
DA 428-4....18 kg – Conversion kit DUW 20 DA 428-4 EXT ....15 kg – Miele charcoal filter DKF 12-1 DA 429-4. - Page 40 Alteration rights reserved / 0410 M.-Nr. 07 769 430 / 00...