Table of Contents
Advertisement
14
en | Installing the Monitor
5.3
Connecting the Composite Video Signal to the Monitor
There are two (2) BNC connectors located on the rear of the monitor for composite video
input and two (2) BNC connectors for composite video outputs (see Figure 3.2).
NOTE: All video inputs are active loop-through. The impedance is automatically set to 75 ohm
by the input of the signal on the input connector, while operating in a single connection mode
(see Figure 5.5). If a cable is also connected to the output connector, the video signal can be
passed on to another monitor connected to it via the active loop-through function. Up to three
(3) monitors may be connected in this manner (see Figure 5.6).
NOTICE! To select between AV1 and AV2, press Input (Figure 3.1, Item 1) located on the front
i
of the monitor
5.4
Connecting the Y/C (S-Video) Signal to the Monitor
There is one (1) mini-DIN type connector for the S-Video (Y/C) input (see Figure 5.3).
NOTE: Both Y and C inputs are terminated with 75 ohm.
Figure 5.3 Y/C Connection Pinout
Reference
1
2
3
4
5.5
Connecting the PC Signal to the Monitor
The monitor can be connected to the analog VGA signal by using the provided VGA cable (D-
SUB to D-SUB).
Figure 5.4 VGA Input
F.01U.078.454 | 1.0 | 2008.03
Input
GND
GND
Y-signal IN or OUT
C-signal IN or OUT
User's Manual
General Purpose LCD Monitors
Bosch Security Systems, Inc.
Advertisement
Table of Contents
