GE JBP79 Installation Instructions Manual
General electric self cleaning free-standing electric range installation instructions
Hide thumbs
Also See for JBP79:
- Use and care & installation manual (41 pages) ,
- Owner's manual (32 pages) ,
- Use and care manual (45 pages)
Table of Contents
Advertisement
Quick Links
Installation
Instructions
Self Cleaning Free-Standing
Electric Range
EER2000, EER3000 JBP24, JBP26, JBP30, JBP35, JBP48, JBP64, JBP65,
JBP66, JBP67, JBP70, JBP78, JBP79, JBP85, JB940, JB960, JB965
"If you have questions, Call 800-GE-CARES
orvisit
our
website a t:
www.G EAppliances.com"
Skill Level:
High !
_
Low
Completion
Time:
1 to 3 Hours
Proper installation
is the responsibility
of the installer.
Product failure due to improper
installation
is not covered under the GE Appliance
Warranty.
See the Owners
Manual for warranty
information.
CAUTION:
Before you begin
Read these instructions
carefully
and
completely.
• IMPORTANT-
Save these instructions
for
local inspector's
use.
• IMPORTANT-
Observe
all governing
codes
and ordinances.
• NOTE TO INSTALLER-
Be sure to leave
these instructions
with the consumer.
• OWNER-
Keep these instructions
for future
refe re nce.
• WARNING-
This appliance
must be
properly
grounded.
Parts Included
Anti-Tip
Bracket and leg leveler
Materials Needed
Lag Bolts
Anchor Sleeves
(For Concrete Floors Only)
4- Wire Cord
4'long
( UL Approved 40 AMP)
OR 3 -Wire Cord
4'long
Tools You Will Need
J
1/4"Nut
driver
Level
Adjustable
wrench
Phillips
Screwdriver
Drill with
1/8" Bit
Pencil
Safety
Glasses
J
5/16" Hex Head
Nut driver
Tape Measure
__F
at-Bladed
Screwdriver
Pub. No. 31-10463
229c4053P447-3
1
Advertisement
Table of Contents
Related Manuals for GE JBP79
Summary of Contents for GE JBP79
- Page 1 Pub. No. 31-10463 229c4053P447-3 Self Cleaning Free-Standing Electric Range EER2000, EER3000 JBP24, JBP26, JBP30, JBP35, JBP48, JBP64, JBP65, JBP66, JBP67, JBP70, JBP78, JBP79, JBP85, JB940, JB960, JB965 of the installer. Product failure due to improper Warranty. See the Owners • NOTE TO INSTALLER-...
-
Page 2: Important Safety Instructions
Install anti-tip bracket packed with range • See Installation Instructions If you pull the range out and away from the wall for any reason, make sure the Anti-Tip bracket is engaged when the range is pushed back against the wall. -
Page 3: Pre-Installation
Place hands on both sides of the door. As you close the door, lift up and have away from the range. Lift door up until the Pack hinges clear the slots. IIoo .oT T.E oooR NOTE: The oven door is very heavy. Be sure you have a firm grip before lifting the oven door off the hinges. -
Page 4: Installation
Installation Instructions Installation See Ilustrations below for all rough-in and spacing dimensions. The range may be placed with 0" clearance the back wall and side walls of the cabinet. MINIMUM DIMENSIONS BETWEEN COOKTOP, WALLS, AND ABOVE THE COOKTOP. Make sure the wall covering,... - Page 5 Failure to wire your oven according to governing codes could result in a hazardous condition. If there are no local codes, your range must be wired and fused to meet the requirements d the National Electrical Code, ANSI/NFPA No. 70-Latest Edition. You can...
-
Page 6: Electrical Connections
Installation Electrical Connections NEW CONSTRUCTION AND FOUR WIRE CORD CONNECTION Complete 4 wire cord kit. Below are 3Screws| step by step instructions how to install the kit. Connection Plate Remove the screws on the terminal block with a 1/4" nut driver or phillips screwdriver. - Page 7 Installation Electrical Connections THREE-WIRE CORD CONNECTION Complete Screws _]_ wire cord kit. by step instructions how to install the kit. Connection Remove the screws on the terminal block with a 1/4" nut driver or phillips screwdriver. Knockout of connection may be taken out Install the three-wire cord and strain relief through the...
-
Page 8: Installing The Anti-Tip Bracket
Decide whether the bracket will be installed on the right or left side of range location. b. If the bracket side of the range has an adjacent cabinet, place the bracket against the back wall and cabinet as shown in Fig. -
Page 9: Installing The Range
Anti-Tip Bracket. Level the Range The range must be level for proper cooking and baking. Install the oven racks.(See Owner's Manual for instructions.) Put a spirit level or a glass... - Page 10 Installation Instructions Installing the Range cont. Replacing the Storage Drawer rail on the guides. Push the drawer in until it stops. Place the drawer Lift the front of the drawer and push in until the stops clear the guides. Lower the front of the drawer and push in until it closes.
-
Page 11: Final Check List
Push in and turn any one of the four surface knobs to "MED" setting to observe that the element glows within 60 seconds. detected within the time limit, recheck the range wiring connections. retest again. If no change is required, and voltage. - Page 12 NOTES Pub. No. 31-10463 229c4053P447-3...