Table of Contents
Advertisement
MIC400 Series Camera | Installation and Operation Manual
3. Break the two solder links and trim away excess solder.
4. Solder the links from the left hand pads to the middle pads as shown next.
Bosch Security Systems
Issue 1
5. The power supply will now deliver +15vac to HD6.
6. Connect the heater wires Brown and Grey to the HD6 termination header
as labelled on the PCB and in.
7. The heaters are thermostatically controlled and will automatically turn on
at +5°C and turn off at +15°C.
8. Check all connections, reseal the PSU enclosure and reapply power.
AAAEN | 20
Hide quick links:
Advertisement
Table of Contents
