IPsec Settings
NOTE:
If IPsec is enabled with incorrect settings, you must disable it using the
Reset IPsec menu on the operator panel.
802.1x
Purpose:
To specify the settings for IEEE 802.1x authentication for encrypted
communication to the printer.
Values:
Protocol
IKE
Pre-Shared Key Sets a shared key. Up to 255 alphanumeric
Re-enter Pre-
Shared Key
IKE SA Lifetime Sets the lifetime for IKE SA from 5 to 28,800
IPsec SA
Lifetime
DH Group
PFS
Remote peers
IPv4 address
Remote peers
IPv6 address
Non IPsec
communication
policy
Select the check box to enable the protocol.
Sets IKE authentication. IKE is fixed to Pre-
Shared Key.
characters, periods, and hyphens can be used.
Enters the shared key again to confirm it.
minutes.
Sets the lifetime for IPsec SA from 5 to 2,880
minutes.
Sets the DH group.
Select the check box to enable the PFS setting.
Sets the IP address to connect to.
Sets the IP address to connect to.
Allows communication with a device which
does not support IPsec.
Dell Printer Configuration Web Tool
243