Page 1
MIC Series Bracketry Installation Guide Bosch Security Systems Installation Guide...
Page 2
Please Note: It is important to seal the MIC Series shielded composite cable connector and the mating plug at the base of the MIC Series camera from water ingress. All MIC Series brackets have an integral ‘O’ ring at the junctions and camera mounting point, in addition a nebar gasket is also supplied to allow a waterproof seal with non MIC Series mounting brackets or poles.
Page 3
M25 side entry conduit fitting point, when fitted with appropriate mount bracket) and MIC Series camera. cables conduit this allows a sealed cable run from the MIC Series power supply unit to the MIC Series camera.
Page 4
MIC-DCA is designed for use with solid or hollow poles and has two M25 MIC Series camera; the MIC-WMB has a deep bowl to accommodate the MIC Series conduit entry points in the side and base and has a 75mm deep void providing plenty of camera shielded composite cable connector, and can be mounted upright or inverted to suit room for the MIC Series camera shielded composite cable connector.
Page 5
MIC Series cameras on the corner of a building, typically to be fitted between the MIC Series camera foot and the top of a CCTV pole or other non providing a large angle of view ( 270°).
Page 6
Wall mount bracket with shallow conduit adaptor and corner mount bracket to provide a secure fixing point for a MIC Series camera on the corner of a building. Wall mount bracket with shallow conduit adaptor and wall mounting spreader plate to provide fixing for a MIC Series camera on a flat masonry / concrete wall.
Page 7
Bracketry Combinations Pole mount bracket showing assembly with a shallow conduit adaptor and wall mount bracket for mounting a MIC Series camera on lamp posts and solid poles. MIC-PMB (pole mount bracket) with MIC-SCA (shallow conduit adaptor) and MIC-WMB (wall mount bracket) Bosch Security Systems F.01U.164.581...
This manual is also suitable for:
Mic-sprMic-pmbMic-scaMic-dcaMic-wmbMic-cmb...
Show all