Operating Instructions The Controls on Your Air Conditioner Care of Product Installation Instructions Important Electrical Safety Installing a J-Model in an Existing Wall Case Helpful Information Things That Are Normal If Something Goes Wrong Before You Call for Service GE Service Numbers Warranty ®...
Write down the model and serial Staple your receipt to the inside back numbers here. They are on a label cover of this manual. You will need it on the front of the control box to obtain service under warranty.
Extension Cord 115V The use of an extension cord is not CAUTION: recommended. However, if an DO NOT use an extension cord with extension cord is required to reach any of the 208/230-volt models.
If you move the switch from a cool or heat setting When the outdoor temperature is lower than to OFF or to a fan setting, wait at least 3 minutes 25 F., heat is provided by the electric heater in before switching back to a cool or heat setting.
The normal range of the temp control is approx- louvers side-to-side to direct the air left or right. imately 60 F to 85 F. The control range may be narrowed by the use of the temperature limiting screws located behind the control panel.
Grille To remove: Pull out from the bottom and lift up from the tabs on the top of the Grille case.
Page 7
The most important thing you can To maintain optimum do to maintain the air conditioner performance, clean is to clean the filter at least every 30 the filter at least days. Clogged filters reduce cool- every 30 days. ing, heating and airflow.
P P a a r r a a l l l l e e l l P P e e r r p p e e n n d d i i c c u u l l a a r r T T a a n n d d e e m m 115V.
Page 9
J-Model Qualifying Questions 3 What is the model number of the chassis currently IMPORTANT! in use? What is the model (or Type) number of the GE strongly recommends the removal of the wall case currently in use? old wall case and the installation of a new Frequently, the J-model adapter kit will apply to GE Wall Case.
Page 10
Base cord Clamp 2 Remove the shipping pad inside the air 6 When the wall outlet is to the left, extend the conditioner next to the compressor. cord under the unit and hold it in place with the clamp. Power cord Clamp 7 Attach the front grille.
You may hear the thermostat click when the compressor cycles on and off. Water will collect in the base pan during high humidity or on rainy days. The water may overflow and drip from the outdoor side D R I P of the unit.
3 minutes to restart the air conditioner to prevent tripping of the compressor overload. • There is a protective time delay (up to 3 minutes) in the heat/cool and heat pump models. Wait 3 minutes for the air conditioner to resume heating or cooling.
Our factory-trained technicians know your appliance inside and out— scheduled at a time that’s 800-GE-CARES convenient for you. so most repairs can be handled in (800-432-2737) just one visit. Service Contracts With a service contract GE With a multiple-year contract, Consumer Service will still be there you’re assured of future service at...
Some states do not allow the exclusion or limitation of incidental or consequential damages. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. To know what your legal rights are in your state, consult your local or state consumer affairs office or your state’s Attorney General.