Table of Contents
Advertisement
Figure 32. Removing the drive from the drive carrier
Next steps
Install the drive into the drive
Installing the drive into the drive carrier
Prerequisites
1. Follow the safety guidelines listed in the
NOTE:
When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs.
Steps
1. Insert the drive into the drive carrier with the drive connector facing towards the rear of the carrier.
2. Align the screw holes on the drive with the screws holes on the drive carrier.
3. Using a Phillips #1 screwdriver, secure the drive to the drive carrier with the screws.
NOTE:
If the drive or SSD carrier has Torx screw
screwdriver to install the drive.
42
Installing and removing system components
carrier.
Safety
instructions.
, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)
Advertisement
Table of Contents
