▶ Do not modify the appliance or flue system in any way. HIf you smell gas Bosch accepts no liability arising from any such actions. This does not A gas leak could potentially cause an explosion. If you smell gas, observe affect your statutory rights.
Servicing risks are avoided.” H Please read these instructions carefully ▶ These instructions are applicable to the Bosch appliance model/s Ensure that the service engineer completes the Service Record in the stated on the front cover only. Benchmark Checklist after each service.
– If the system pressure is gravity fed and cannot be increased via a filling link, then the appliance can be converted to allow If you would like to know more about servicing options from Bosch, connection to a semi-sealed heating system please visit www.worcester-bosch.ie...
0010036333-001 Fig. 5 Bottom panel To replace the bottom panel, ensure that the tabs [B] line up with the edges of the boiler [C] and push into place until the tabs [A] click into place. Condens 4700iW – 6721864484 (2023/04)
Page 7
– Pull the key straight down to remove. Please remember to store – The pressure menu indicator moves and the displayed message the key in a safe place. may change [6]. Condens 4700iW – 6721864484 (2023/04)
• Confirm a selection • Save setting • DHW eco/preheat " Back arrow • Exit menu (without saving changes) 1) When the display is in power save mode the ok button will re-activate the screen Condens 4700iW – 6721864484 (2023/04)
▶ It is advised to make a note of these settings before adjusting so that you can return to these optimum settings in the future. 1) The maximum value can be reduced by the service technician. Condens 4700iW – 6721864484 (2023/04)
▶ Press the d key. 1) Only available with installed Key (accessories) 2) Only available with automatic filling facility (accessory) 3) Allows manual control of heating during loss of Radio Frequency (RF) Key signal Table 7 Settings Menu Condens 4700iW – 6721864484 (2023/04)
▶ Press the ok key. The new time is saved. Next time entry is selected. Fig. 10 Appliance minimum clearances Add one additional switching time block by selecting +. Delete an existing switching time block by selecting Condens 4700iW – 6721864484 (2023/04)
Page 12
– This clearance will not apply if the appliance is sited within 300mm of a door way and the door frame is the only obstruction. Minimum clearances must be observed to any obstruction/ surface, (dark shaded areas, figures 11 and 12). Condens 4700iW – 6721864484 (2023/04)
– If the working area does not extend to the loft hatch, any boards which are provided for access must be securely fixed to the ceiling joists. The access boarding must be at least 600mm wide. Joints must be properly supported and must not be overlapped. Condens 4700iW – 6721864484 (2023/04)
In the event of an appliance fault or breakdown please contact Bosch Basic checks appointments team on 0330 123 9339. Your advisor will arrange for an Some items to check before placing a call are: engineer to call with the minimum of delay;...
– Care must be taken at pedestrian areas where this water may freeze and create a slip hazard. ▶ Bosch have available on our website helpful videos in the Customer Service section to aid in thawing a frozen pipe. ▶ Reset the appliance and wait two or three minutes for the appliance to restart.
The boiler is fine Contact a service Contact a service The boiler is fine The boiler is fine engineer engineer Table 12 System gassing flow chart Condens 4700iW – 6721864484 (2023/04)
Used batteries must be disposed of in local collection systems. 2) Hot water is available at the boiler. Delivery time to the tap will vary on the pipework design and tap distance from the boiler Condens 4700iW – 6721864484 (2023/04)
• During the period of this guarantee any components of the appliance keyholes etc. are reduced by using a suitable draught excluder. that are proven to be faulty or defective in manufacture will be exchanged or repaired free of charge by Bosch Thermotechnology WARNING Ltd.
2) Low temperature means for condensing boilers 30 °C, for low-temperature boilers 37 °C and for other heaters 50 °C return temperature (at heater inlet). 3) XL tapping cycle declared in accordance with EN 13203-2, clause 5.2 Table 13 Product data on energy consumption Condens 4700iW Condens 4700iW – 6721864484 (2023/04)
Page 20
2) Low temperature means for condensing boilers 30 °C, for low-temperature boilers 37 °C and for other heaters 50 °C return temperature (at heater inlet). 3) XL tapping cycle declared in accordance with EN 13203-2, clause 5.2 Table 14 Product data on energy consumption Condens 4700iW Condens 4700iW – 6721864484 (2023/04)
You can contact our Data Protection Officer under: Data Protection Officer, Information Security and Privacy (C/ISP), Robert Bosch GmbH, Postfach 30 02 20, 70442 Stuttgart, GERMANY. You have the right to object, on grounds relating to your particular...