Table of Contents
Advertisement
Steps
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Slide the memory module firmly into the slot at an angle and press the memory module down until it clicks into place.
NOTE:
If you do not hear the click, remove the memory module and reinstall it.
NOTE:
Repeat step 1 and 2 if there are two memory modules.
Next steps
1. Install the
system-board
2. Install the stand.
3. Install the
bottom
cover.
4. Install the
back
cover.
5. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
2. Remove the
back
cover.
3. Remove the
bottom
cover.
4. Remove the stand.
5. Remove the
system-board
About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.
shield.
After working inside your
Before working inside your
shield.
computer.
computer.
Removing and installing components
23
Advertisement
Table of Contents
