Using The Self-Cleaning Oven - GE JBP15DMBB Use And Care Manual
Coil top and radiant top models
Hide thumbs
Also See for JBP15DMBB:
- Installation instructions (2 pages) ,
- Owner's manual (80 pages) ,
- Owner's manual and installation instructions (52 pages)
Table of Contents
Advertisement
Available languages
Available languages
Using the self-cleaning oven.
Never force the latch handle. Forcing the handle will damage the door lock mechanism.
The oven door must be closed and all controls set correctly for the cycle to work properly.
Wipe up heavy soil on the oven
bottom.
OVEN
TEMP
Appearance may vary.
(on some models)
CAUTION:
Never place cooking utensils, baking stones, foil, or any other items on the
oven floor. Even items rated for high temperature may permanently adhere to the oven bottom or
cause heat damage to the oven, flooring, or items in storage drawers.
Before a Clean Cycle
For the first self-clean cycle, we recommend
venting your kitchen with an open window or
using a ventilation fan or hood.
Remove the racks, any broiler pan, broiler grid, all
cookware and any aluminum foil from the oven.
The oven racks can be self-cleaned, but they will
darken, lose their luster and become hard to slide.
Do not use commercial oven cleaners or oven
protectors in or near the self-cleaning oven.
A combination of any of these products plus the
high clean cycle temperatures may damage
the porcelain finish of the oven.
Soil on the front frame of the range and outside
the gasket on the door will need to be cleaned by
hand. Clean these areas with hot water, soap-filled
steel-wool pads or cleansers such as Soft Scrub
Rinse well with clean water and dry.
Do not clean the gasket. The fiberglass material
of the oven door gasket cannot withstand
How to Set the Oven for Cleaning
Follow the directions in the Before a Clean Cycle
section.
Latch the door.
Turn the OVEN TEMP knob to CLEAN.
The Clean Time is 4 hours and 20 minutes. The
self clean light will come on and stay on until
the self clean cycle is complete.
The oven shuts off automatically when the
clean cycle is complete.
How to Set the Oven for Cleaning
Follow the directions in the Before a Clean Cycle
section.
Latch the door.
Touch the SELF CLEAN pad.
Touch the + or – pads until the desired
Clean Time is displayed.
The Clean Time is normally 4 hours and 20
minutes. You can change the Clean Time to any
time between 3 and 5 hours, depending on the
amount of soil in your oven.
Touch the START/ON pad.
abrasion. It is essential for the gasket to remain
intact. If you notice it becoming worn or frayed,
replace it.
Wipe up any heavy spillovers on the oven bottom.
Make sure the oven light bulb cover is in place
and the oven light is off.
CAUTION:
pans (if so equipped) should never be cleaned
in the self-cleaning oven.
IMPORTANT: The health of some birds is
extremely sensitive to the fumes given off
during the self-cleaning cycle of any range.
Move birds to another well ventilated room.
.
®
(on models with knobs)
After a clean cycle, turn the OVEN TEMP
knob to OFF and slide the latch handle to
the left as far as it will go.
To cancel self clean cycle, turn
OVEN TEMP knob to off and slide latch to left as
far as it will go. Wait until self clean light stops
blinking. Use oven as desired.
NOTE: Never force the latch. If the oven is
too hot, you will not be able to slide the latch.
Allow the oven to cool.
(on some models with press pads)
The self-clean cycle will automatically begin
after CLEAN is displayed and the time
countdown appears in the display.
While the oven is self-cleaning, you can touch the
CLOCK pad to display the time of day. To return to
the clean countdown, touch the SELF CLEAN pad.
The oven shuts off automatically when the
clean cycle is complete, and 0:00 will flash in
the display.
Slide the latch handle to the left as far as it
will go and open the door.
NOTE: Never force the latch. If the oven is too
hot, you will not be able to slide the latch. Allow
the oven to cool.
GEAppliances.com
The grates and drip
23
Hide quick links:
Advertisement
Chapters
Table of Contents
