VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.zanussi.com/support SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage.
By clients in hotels, motels, bed and breakfast and other – residential type environments. To avoid contamination of food respect the following • instructions: do not open the door for long periods; – clean regularly surfaces that can come in contact with food –...
Page 4
• Make sure the air can circulate around the appliance. The appliance contains flammable gas, • At first installation or after reversing the door isobutane (R600a), a natural gas with a high level wait at least 4 hours before connecting the of environmental compatibility.
• This appliance contains hydrocarbons in the • Door gaskets will be available for 10 years after cooling unit. Only a qualified person must do the the model has been discontinued. maintenance and the recharging of the unit. DISPOSAL • Regularly examine the drain of the appliance and if necessary, clean it.
Page 6
DIMENSIONS ² the height, width and depth of the appliance including the handle, plus the space necessary for Overall dimensions ¹ free circulation of the cooling air 1850 Overall space required in use ³ 1950 ¹ the height, width and depth of the appliance without the handle and feet 1189 ³...
Page 7
To ensure appliance's best functionality, you should CAUTION! If you position the not install the appliance in the nearby of the heat appliance against the wall, use back source (oven, stoves, radiators, cookers or hobs) or spacers provided or keep the minimum in a place with direct sunlight.
CONTROL PANEL by one position. The corresponding LED blinks for a while. 2. Touch the temperature regulator until the required temperature is selected. The set temperature will be reached within 24 hours. After a power failure the set temperature remains stored. FASTFREEZE FUNCTION The FastFreeze function is used to perform pre- freezing and fast freezing in sequence in the freezer...
Page 9
MOVABLE SHELVES The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. 2. This shelf can be tilted to store unsealed bottles. To obtain this result, place front hooks of the shelf one level higher than the rear hooks.
The maximum amount of food that can be frozen drawers, except for the bottom drawer which needs without adding other fresh food during 24 hours is to be in place to provide good air circulation. specified on the rating plate (a label located inside Keep the food no closer than 15 mm from the door.
Page 11
HINTS FOR STORAGE OF FROZEN FOOD • Ensure that the packaging is not damaged - the food could be deteriorated. If the package is • The medium temperature setting ensures good swollen or wet, it might have not been stored in preservation of frozen food products.
• Always use closed containers for liquids and for • Fruit and vegetables: clean thoroughly (eliminate food, to avoid flavours or odours in the the soil) and place in a special drawer compartment. (vegetable drawer). • To avoid the cross-contamination between •...
that break away before defrosting is complete. A certain amount of frost will always form on the Use the supplied ice scraper for this purpose. freezer shelves and around the top compartment. 5. When defrosting is complete, dry the interior Defrost the freezer when the frost layer reaches a thoroughly.
Page 14
Problem Possible cause Solution The compressor operates con- Temperature is set incorrectly. Refer to "Control Panel" chap- tinually. ter. Many food products were put Wait a few hours and then in at the same time. check the temperature again. The room temperature is too Refer to "Installation"...
Page 15
Problem Possible cause Solution Temperature set in the appli- Set a higher temperature. Re- ance is too low and the ambi- fer to "Control Panel" chapter. ent temperature is too high. Water flows on the rear plate During the automatic defrost- This is correct.
Page 16
Problem Possible cause Solution There is no cold air circulation Make sure that there is cold air in the appliance. circulation in the appliance. Refer to "Hints and Tips" chap- ter. Some specific surfaces inside This is a normal state. the fridge compartment are warmer at some times.
NOISES SSSRRR! BRRR! CLICK! HISSS! BLUBB! TECHNICAL DATA The technical information is situated in the rating It is also possible to find the same information in plate on the internal side of the appliance and on EPREL using the link https://eprel.ec.europa.eu the energy label.
ENVIRONMENTAL CONCERNS with the symbol with the household waste. Recycle materials with the symbol . Put the Return the product to your local recycling facility or packaging in relevant containers to recycle it. Help contact your municipal office. protect the environment and human health by recycling waste of electrical and electronic appliances.