GE JBS27 Owner's Manual And Installation Instructions page 33
Electric coil & radiant ranges
Hide thumbs
Also See for JBS27:
- Owner's manual (80 pages) ,
- Use and care manual (80 pages) ,
- Owner's manual and installation instructions (53 pages)
Table of Contents
Advertisement
Glass surface—potential for permanent damage
Our testing shows that if
you are cooking high sugar
mixtures such as jelly or
fudge and have a spillover,
it can cause permanent
damage to the glass surface
unless the spillover is
immediately removed.
Metal Marks and Scratches
Be careful not to slide pots and pans
across your cooktop. It will leave
metal markings on the cooktop
surface.
These marks are removable using
the CERAMA BRYTE
®
Cooktop Cleaner with the CERAMA
BRYTE
®
Cleaning Pad for Ceramic
Cooktops.
Cooktop Seal
To clean the cooktop seal around the
edges of the glass, lay a wet cloth on it
Damage from Sugary Spills and Melted Plastic
Turn off all surface units. Remove
hot pans.
Wearing an oven mitt:
a. Use a single-edge razor blade
scraper (CERAMA BRYTE
Ceramic Cooktop Scraper) to
move the spill to a cool area on
the cooktop.
b. Remove the spill with
paper towels.
To Order Parts
To order CERAMA BRYTE
Cooktop Cleaner and the cooktop
scraper, please call our toll-free number:
National Parts Center . . . . . . 800.626.2002
CERAMA BRYTE
®
Ceramic
Cooktop Cleaner . . . . . . . . . .# WX10X300
CERAMA BRYTE
®
Ceramic
Cooktop Scraper . . . . . . . . .# WX10X0302
Kit . . . . . . . . . . . . . . . . . . . . . .# WB64X5027
(Kit includes cream and cooktop scraper)
CERAMA BRYTE
®
Cleaning Pads for
Ceramic Cooktops . . . . . . . .# WX10X350
If pots with a thin overlay of
aluminum or copper are allowed to
boil dry, the overlay may leave black
discoloration on the cooktop.
This should be removed immediately
before heating again or the
Ceramic
discoloration may be permanent.
WARNING: Carefully check the bottom of pans
for roughness that would scratch
the cooktop.
for a few minutes, then wipe clean with
nonabrasive cleaners.
.
Any remaining spillover should be
left until the surface of the cooktop
has cooled.
Don't use the surface units again
®
until all of the residue has been
completely removed.
NOTE: If pitting or indentation in the glass
surface has already occurred, the cooktop glass
will have to be replaced. In this case, service will
be necessary.
®
Ceramic
GEAppliances.com
33
Advertisement
Table of Contents
