Page 1
Operating and installation instructions Rangehood To prevent the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. en-AU M.-Nr. 12 039 260...
Description of the functions ................16 Before using for the first time ................17 Selecting extraction mode or recirculation mode..........17 Setting up Miele@home ..................17 Connecting via the App.................. 18 Connecting via WPS ..................19 Signing out of Wi-Fi (reset to factory settings) ..........20 Setting up Con@ctivity ..................
Page 3
Contents Cleaning and care ..................... 33 Housing ....................... 33 Important information for appliances with stainless steel surfaces ....33 Operating hours counter ..................34 Grease filter ......................34 Change grease filters..................36 NoSmell active charcoal filters ................36 Resetting the charcoal filter operating hours counter ........37 Disposing of the charcoal filters ..............
It must only be used to extract vapours and remove odours from cooking. Any other usage is at the owner's risk. Miele cannot be held liable for damage resulting from incorrect or improper use or operation. The rangehood cannot be used to ventilate the room in which it is installed in recirculation mode above a gas cooktop.
Page 5
Warning and Safety instructions This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning its use by a person responsible for their safety, and are able to recognise the dangers of misuse.
Page 6
Repairs and other work by unqualified persons could be dangerous. Installation, maintenance work and repairs to electrical appliances must only be carried out by a Miele approved service technician. A damaged appliance can be dangerous. Check it for visible signs of damage.
Page 7
The lamps are a built-in component of the lighting. Replacement lamps may only be installed by a Miele authorised technician. During installation, maintenance and repair work, the appliance must be disconnected from the mains electricity supply.
Page 8
Warning and Safety instructions Using at the same time as other heating appliances that depend on the air from the room Danger of toxic fumes! Great care should be taken when using the rangehood in the same room or the same area of the house as another heating appliance that depends on the air from the room.
Page 9
Warning and Safety instructions In order to ensure safe operation and to prevent gases given off by a heating appliance from being drawn back into the room, when the rangehood and the heater are both operated simultaneously, an underpressure in the room of 0.04 mbar (4 Pa) is the maximum permissible.
Page 10
Warning and Safety instructions Correct use Open flames are a fire hazard! Never use an open flame under the rangehood. To avoid the danger of fire, do not flambé or grill over an open flame. When switched on, the rangehood could draw flames into the filter. Kitchen grease deposits could ignite.
Page 11
Warning and Safety instructions Do not use the rangehood without the filters in place. This way you will avoid the risk of grease and dirt getting into the appliance and hindering its smooth operation. The rangehood can get very hot during cooking due to heat rising from the cooktop.
Page 12
The steam could reach electrical components and cause a short circuit. Accessories and spare parts Use only genuine original Miele spare parts. If spare parts or accessories from other manufacturers are used, the warranty will be invalidated, and Miele cannot accept liability. ...
Caring for the environment Disposal of the packing Disposing of your old material appliance The transport and protective packaging Electrical and electronic appliances has been selected from materials which often contain valuable materials. They are environmentally friendly for also contain specific materials, disposal, and can normally be recycled.
Page 15
Guide to the rangehood a Exhaust connection b Control panel c Charcoal filter Single-use or reactivatable charcoal filters Optional accessory for recirculation mode d Grease filter e Pull-out deflector plate f Cooktop lighting g Sensor for switching the rangehood on and off h Sensors for switching the fan on and off and for setting the fan power level i Sensor for the run-on function j Sensor for the grease filter operating hours counter...
Description of the functions Depending on the model of the Recirculation mode rangehood, the following options are (available as an optional accessory with available: a conversion kit and charcoal filters: see “Technical Data”) Air extraction mode The air is drawn in and cleaned first by The air is drawn in and cleaned by the the grease filter and then by charcoal grease filter and directed outside.
Miele Touch the On/Off sensor . App. All symbols light up with reduced If your Miele cooktop is connected to a brightness. home Wi-Fi network, you can control Press and hold the run-on option the rangehood automatically via the control ...
Start the appliance registration in the App. Follow the login steps. Connecting via the App If requested to activate Wi-Fi on the The Miele App can be used to connect rangehood, proceed as follows: to your network. Install the Miele App on your mobile...
Before using for the first time Touch the On/Off sensor . Connecting via WPS All symbols light up with reduced Your Wi-Fi router must support WPS brightness. (Wi-Fi Protected Setup). Touch the On/Off sensor . All symbols light up with reduced ...
With an existing Wi-Fi connection 2 and Useful tip: If your Wi-Fi router does not 3 will light up constantly. support WPS, please connect via the The rangehood is ready for Miele App. disconnection during the next two minutes.
Setting up Con@ctivity Con@ctivity is the direct communication Touch the 1 control. system between an electric Miele cooktop and a Miele rangehood. It enables the rangehood to operate automatically depending on the 2 will light up constantly, 3 will flash on operational state of a Miele cooktop and off.
(Con@ctivity 3.0) connection (Con@ctivity 3.0) Prerequisites: Prerequisite: - Home Wi-Fi network - Wi-Fi enabled Miele cooktop - Wi-Fi enabled Miele cooktop If you do not have a home network, you can establish a direct connection Connect the rangehood and cooktop...
Before using for the first time Start the Wi-Fi connection on the cooktop. For further details, see the cooktop operating instructions. When successfully connected 2 and 3 will light up constantly. Quit connection mode on the rangehood by touching the run-on control .
Operation (automatic mode) When Con@ctivity is active, the rangehood always operates in automatic mode (see “Before using for the first time – Setting up Con@ctivity”). If you wish to manually operate the rangehood, see “Operation (manual mode) – Cooking without Con@ctivity”. Examples for power levels 1 to B Reaction time Cooking with Con@ctivity...
Operation (automatic mode) Cooking process Switching off For example, you switch on a cooking Switch off all cooking zones. zone at the highest power level to The rangehood fan will reduce its power heat a pan for frying. After approx. level in stages over the next few 10 seconds to 4 minutes, you then minutes and will then switch itself off.
Operation (automatic mode) You can also operate the rangehood Leaving automatic mode manually for a complete cooking temporarily process. To leave automatic mode temporarily To do so switch the rangehood fan on during cooking: before the cooktop. Manually select a different power If the rangehood fan and the cooktop level, or have been switched off for at least 30...
Operation (manual mode) Cooking without Con@ctivity Selecting a power level (manual mode) For light to heavy cooking vapours and odours, select from power levels 1 to 3. The rangehood can be operated manually if: For short periods of cooking food with intensive vapours and a strong aroma, - the Con@ctivity function is not e.g.
Operation (manual mode) Selecting the run-on time Dimming/Switching the cooktop lighting on/off It is advisable to run the fan for a few minutes after cooking has finished. This You can switch the cooktop lighting helps to remove any lingering vapours on and off by pulling the deflector and odours from the air.
Changing settings Touch the On/Off sensor . Altering the grease filter operating hours counter All symbols light up with reduced brightness. You can set the operating hours counter to suit the type of cooking you do. Press and hold the run-on option control ...
Changing settings Altering or deactivating the Deactivating Power charcoal filter operating hours management counter Keep in mind that deactivating this function may increase energy Charcoal filters are needed for consumption. recirculation mode. You can set the operating hours counter Activating/deactivating Power to suit the type of cooking you do.
Changing settings If you do not confirm your selection of setting within 4 minutes, the rangehood will revert to the previous setting. Buzzer for the sensors When a function is selected with the sensors, a short buzzer will sound for confirmation. The buzzer can be switched off.
Energy saving tips This rangehood operates very efficiently - Use the Con@ctivity function. The and economically. The following will rangehood will switch on and off help you to save even more energy automatically. The rangehood will when using it: select the optimum power level for the cooking you are doing, which - Ensure that there is sufficient ensures low energy consumption.
Housing To prevent the surfaces from quickly becoming dirty again, we recommend General treating them with a stainless steel care product (available from Miele). The surfaces and controls are susceptible to scratches and Important for appliances with glass abrasion.
Cleaning and care The operating hours control reminds Operating hours counter you to regularly clean the grease filters The rangehood registers the length of by illuminating the grease filter time it has been operated. symbol . When the grease filter symbol or the Removing the grease filter charcoal filter symbol ...
Page 35
Cleaning and care Unsuitable cleaning agents After cleaning After cleaning, leave the grease filter Unsuitable cleaning agents can cause damage to the surface of the filters if to dry on an absorbent surface before used regularly. refitting it. Do not use: ...
The grease filter symbol goes out. Charcoal filters are available to order via the Miele online shop (see end of this Change grease filters booklet for contact details) or directly Regular use and cleaning can cause the from Miele.
Cleaning and care Fitting/Replacing the charcoal filters When to change the NoSmell active charcoal filters The matching frames must be installed Replace the charcoal filters when they in order to use the charcoal filters. no longer absorb kitchen odours Follow the directions on the effectively, or at least every 6 months.
*INSTALLATION* Installation Before installation Before installation, it is important to read the information given on the 1 non-return flap following pages as well as the for fitting into the exhaust connection “Warning and Safety instructions” at on the motor unit (not needed for the beginning of this booklet.
*INSTALLATION* Installation Installation materials for recirculation mode You need the following optional 4 screws, M4 x 8 mm accessories for recirculation mode. 5 (9)* screws, 4 x 15 mm DKFS 31-x installation kit 4 screws, 4 x 30 mm contains 2 holders and 2 charcoal filters (DKFS 31-P with single-use charcoal filters or DKFS 31-R with reactivatable charcoal filters) 8 (12)* screws, 4 x 15 mm...
*INSTALLATION* Installation Appliance dimensions Diagram 1: DAS 4630 in a 600 mm wide cabinet. The drawing is not to scale...
Page 41
*INSTALLATION* Installation Diagram 2: DAS 4930 in a 900 mm wide cabinet. The drawing is not to scale See diagram 1 for side view...
Page 42
*INSTALLATION* Installation Diagram 3: DAS 4930 in a 600 mm wide cabinet or in a 900 mm wide cabinet with side compartments. The drawing is not to scale See diagram 1 for side view Footnotes for diagrams 1 to 3: a Extraction or recirculation with conversion kit DUU 150 * In this installation situation, the deflector plate is flush with the front edge of the cabinet niche.
*INSTALLATION* Installation Safety distance (S) The minimum distances between the cooking surface of a cooktop (pan support(s) for gas models) and the bottom of the rangehood are as follows, unless a greater distance is specified by the manufacturer of your cooking appliance.
*INSTALLATION* Installation - If the ducting has flaps, these must Connection for air extraction be opened when the rangehood is Before installation, it is important switched on. to read the information given on the Any constriction of the airflow will following pages as well as the reduce extraction performance and “Appliance dimensions”...
If the exhaust air is ducted through an outside wall, a Miele wall vent or a Miele roof vent (available as an optional accessory) is recommended. These are fitted with an integrated non-return flap.
*INSTALLATION* Installation Silencer In recirculation mode the silencer needs to be positioned between the exhaust connection and the exhaust grille . Please ensure there is adequate To achieve even further reductions in installation space. noise levels, a special silencer (optional accessory) can be fitted in the ducting system.
Connecting the rangehood to multi- provided in the domestic installation socket adapters or extension cables and in this Miele product must also be can overload the cables. assured in their function and operation For safety reasons, do not use an...
Service Contact in case of fault In the event of any faults which you cannot remedy yourself, please contact Miele. You can book a Miele customer service call-out online at www.miele.com.au/service or www.miele.co.nz/service. Contact information for Miele can be found at the end of this booklet.
Total rated load 293 W Voltage, frequency AC 230 V, 50 Hz Fuse rating 10 A Mains connection cable length 1.5 m Weight DAS 4630 14 kg DAS 4930 16 kg Wi-Fi module Frequency band 2.400–2.4835 GHz Maximum transmission power < 100 mW Optional accessory for recirculation mode...
Page 51
183 Featherston Street Miele Experience Centre South Melbourne: Wellington 6011 206-210 Coventry Street South Melbourne, VIC 3205 0800 464 353 (0800 4 MIELE) Miele Experience Centre and Office Sydney: www.miele.co.nz 3 Skyline Place Frenchs Forest, NSW 2086 Miele Experience Centre and Office Brisbane:...
Page 52
DAS 4630, DAS 4930 en-AU M.-Nr. 12 039 260 / 01...