Bosch HPC 400 Operating Instructions Manual page 32
User interface
Hide thumbs
Also See for HPC 400:
- Installation instructions for contractors (30 pages) ,
- Operating instructions manual (23 pages)
Table of Contents
Advertisement
32 | Calling up information about the system
Menu: Heating/Cooling
The menu items in this menu are only available for installed
heating circuits.
Menu item
description
Operating mode
Currently valid operating mode in the
heating/cooling
selected heating circuit (Heating, Idle,
Cooling)
Set room temp.
The desired room temperature that is
currently valid in the selected heating
circuit:
•
In automatic mode the desired
room temperature can change
several times a day, if necessary
•
Permanently constant in optimised
operation
Actual room temp. Currently measured room temperature
in the selected heating circuit
Actual flow temp.
Currently measured flow temperature
in the selected heating circuit
Table 36 Information about the heating
Menu: DHW
This menu is only available if at least one DHW system is
installed.
Menu item
description
Set temp.
Required DHW temperature
Actual temp.
Current measured DHW temperature
Table 37 Information about DHW
Menu: Pool
This menu is only available if a heated swimming pool (pool
module accessory required) is installed.
Menu item
description
Pool set point
Required water temperature in the
temp.
swimming pool
Actual temp. pool
Current measured water temperature
in the swimming pool
Table 38 Information regarding the heated swimming pool
6 720 817 986 (2015/07)
CLIMATE CONTROL SYSTEMS
Menu: Operating data
Apart from the first menu item, the menu items in this menu are
only available for installed heat pumps. If two heat pumps are
operated in a cascade, all of the menu items are shown
separately for each heat pump apart from the hours run on the
control.
Menu item
Operating hours
Control
Output additional
heat
Operating hours
compressor
heating
Operating hours
compressor
cooling
Operating hours
compressor DHW
Operating hours
compressor pool
Number of starts
heating
Number of starts
cooling
Number of starts
DHW
Number of starts
pool
Table 39 Information regarding operating the heat pump
Menu: Consumed energy
In this menu, the cumulated amounts of energy consumed by
the heat pump and the electric booster heater are displayed as
a total (Consumed energy > Total) and separately for each
load.
If two heat pumps are operated in a cascade, all of the menu
items are shown separately for each heat pump.
VOGEL
NOOT
&
description
Hours run by the control since the heat
pump was commissioned or since the
last reset.
Output of the electric booster heater
since commissioning or since the last
reset.
Hours run by the compressor in
heating mode since commissioning or
since the last reset.
Hours run by the compressor in cooling
mode since commissioning or since
the last reset.
Hours run by the compressor in DHW
operation since commissioning or
since the last reset.
Hours run by the compressor in pool
operation since commissioning or
since the last reset.
Number of compressor starts in
heating mode since commissioning or
since the last reset.
Number of compressor starts in
cooling mode since commissioning or
since the last reset.
Number of compressor starts in DHW
operation since commissioning or
since the last reset.
Number of compressor starts in pool
operation since commissioning or
since the last reset.
HPC 400
Hide quick links:
Advertisement
Table of Contents
