Whirlpool AKT 920 Product Description Sheet
Hide thumbs
Also See for AKT 920:
- Use and care manual (76 pages) ,
- Use and care manual (29 pages) ,
- Use and care manual (76 pages)
Advertisement
Quick Links
AKT 920/ AKT 922
GB
LIGHTING THE BURNERS
•
To ignite one of the burners, turn the relative knob anti-clockwise to the maximum flame setting
•
Press the knob against the control panel to ignite the burner.
•
After the burner has ignited, keep the knob pressed for about 5 seconds to allow the thermocouple to warm up.
This burner safety device shuts off the gas supply to the burner if the flame goes out accidentally (because of sudden
draught, an interruption in the gas delivery, boiling over of liquids, etc.).
•
The device must not be pressed for more than 15 sec. If, after that time has elapsed, the burner does not
remain lit, wait at least one minute before trying to light it again.
-
The burner might go out when the knob is released. This means that the thermocouple has not warmed up enough.
In this case, repeat the operations described above.
PRATICAL ADVICE FOR USING THE BURNERS
For better burner performance, please stick to the following
rules:
-
Use pots and pans that fit the burners (see table on the
right).
-
Only use flat-bottomed pots and pans.
-
Use the correct amount of water for cooking foods and
keep the pot covered.
-
In the case of pans with convex bottoms (WOK), use
the support grille provided, which should be positioned
only on the 4 ring burner.
Due to continued product development, Whirlpool
reserves the right to change specifications or model
availability without notice.
5019 319 62097
PRODUCT DESCRIPTION SHEET
1.
Removable panstand grids
2.
Auxiliary burner
3.
Fish kettle burner
Rapid burner
4.
Semi-rapid burner
5.
4 ring burner (WOK)
6.
4 ring burner control knob
7.
Auxiliary burner control knob
8.
Fish kettle burner control knob
9.
10.
Rapid burner control knob
11.
Semi-rapid burner control knob
SYMBOLS
Tap closed
Maximum flame
Minimum flame
.
Burner
Pot Ø
Auxiliary
from 8 to 14 cm
semi-rapid
from 16 to 22 cm
Rapid
from 24 to 26 cm
4 rings
from 24 to 26 cm
Fish kettle (23 x 8 cm)
31 x 16 cm
To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation.
DIMENSIONS AND DISTANCES TO BE MAINTAINED (mm)
NOTE: In case of installation of a hood above the cooktop, please refer to the hood instructions for the correct
distance.
NG
BURNER
Pressure
Injector
(kPa)
Front RHS (Semi-rapid)
1.00
Rear RHS (Rapid)
1.00
Front LHS (4 rings WOK)
1.00
Rear LHS (Auxiliary)
1.00
Middle HS (Fish kettle)
1.00
ELECTRIC SUPPLY: 230 -240 V - 50 Hz
ULPG
Rate
Pressure
Injector
(mm)
MJ/h
(kPa)
(mm)
1.15
7.0
2.75
0.60
1.60
12.5
2.75
1.00
1.75
14.8
2.75
1.00
0.85
4.0
2.75
0.55
1.60
13.0
2.75
0.95
AU
Rate
MJ/h
5.0
15.0
15.1
4.0
11.5
Advertisement
Related Manuals for Whirlpool AKT 920
Summary of Contents for Whirlpool AKT 920
- Page 1 ELECTRIC SUPPLY: 230 -240 V - 50 Hz the support grille provided, which should be positioned only on the 4 ring burner. Due to continued product development, Whirlpool reserves the right to change specifications or model availability without notice. 5019 319 62097...
- Page 2 20 mm from the bottom of the hob. In the case that you ROOM VENTILATION intend to install an oven beneath the hob, make sure that it is manufactured by Whirlpool and equipped with a cooling system. The manufacturer declines all liability if another brand oven is installed beneath the To ensure correct operation of the appliance, the room size in which it is to be installed shall be in accordance with AS5601.
- Page 3 INSTALLATION ELECTRICAL CONNECTION • The electrical connections must comply with GAS CONNECTION local regulations. • The data relevant to the voltage and power Check the “gas type” sticker attached to the hotplate. Details of the injector sizes used are recorded on the data plate Earth absorption are indicated on the rating plate.
- Page 4 Manufacturer: food spills (water, sauce, coffee, etc.) should be wiped away before they dry. Whirlpool Europe S.r.l. Clean with warm water and neutral detergent, and then dry with a soft cloth or chamois. Remove baked-on dirt with Viale G. Borghi, 27 specific cleaners for stainless steel surfaces.