Table of Contents
Advertisement
GE H
EALTHCARE
D
FL091021, R
IRECTION
3-8-5-3
Configuration of Modality Worklist Services (cont'd)
Test Connectivity with the Vivid HL7 Gateway
The purpose of this test is to verify that the Vivid i n has connectivity with the Vivid HL7 Gateway.
1.) From either the Current or Dataflow view, expand the Dataflow incorporating the Gateway Modality
Worklist service.
2.) Expand the Gateway destination device.
3.) Select the Gateway Modality Worklist service.
4.) Click the Check button.
-
-
Troubleshoot Connectivity with the Gateway
If connection between the Vivid i n and the HIS failed, the following are typical causes:
1.) No network connection.
2.) IP address and/or port number was incorrectly entered when configuring the Gateway Modality
Worklist service.
3.) Mitra support personnel have not yet configured the Gateway to accept Modality Worklist queries
from the Vivid i n.
Verify that the Vivid i n computer name matches the value specified for the Gateway Modality Worklist
service and that it also matches the value supplied to the Mitra support personnel.
Configure the Export to HL7 Path
1.) Enter the configuration screen for the EchoPAC PC.
2.) Press the Connectivity button.
3.) Select the Tools tab.
4.) In the section labeled Export Paths, make the following changes:
a.) For the Export To HL7 path, enter the following information:
b.) Verify that Text is select for the Export file format.
3-90
5
EVISION
If connectivity was achieved, then a green check should be displayed next to the name of the
Gateway's Modality Worklist service.
If connectivity was not achieved, then there will be a red X next to the name of the Gateway's
Modality Worklist service.
\\ < Name or IP Address of the Vivid HL7 Gateway>\POLL_DIR
Example:
\\Gateway\POLL_DIR
Section 3-8 - Connectivity Setup
V
S
M
IVID I N
ERVICE
ANUAL
Advertisement
Table of Contents
