Installing The System Feet - Dell EMC PowerEdge T440 Installation And Service Manual
Hide thumbs
Also See for EMC PowerEdge T440:
- Installation and service manual (156 pages) ,
- Simple operation manual (9 pages) ,
- Manual (150 pages)
Table of Contents
Advertisement
Figure 17. Removing the system feet
Next steps
If applicable,
install the system feet or the caster wheel
Installing the system feet
Prerequisites
CAUTION:
Install the feet on a stand-alone tower system to provide stability to the system. An unstable system
might tip over and cause injury to the user or damage to the system.
1. Follow the safety guidelines listed in
2. Place the system on its side, on a flat, stable surface.
Steps
1. Align the three tabs on the system foot with the three slots on the base of the system.
2. Using the Phillips #2 screwdriver, secure the screw that secures the foot to the base of the system.
a. Repeat the above steps to install the remaining system feet.
assembly.
Safety
instructions.
Installing and removing system components
31
Advertisement
Table of Contents
