hit counter script

Wiring Connection; Power Connections - GE SG Series Installation Manual

Hide thumbs Also See for SG Series:
Table of Contents

Advertisement

3.8

WIRING CONNECTION

WARNING!
UPS installation and connection must be performed by QUALIFIED SERVICE
PERSONNEL ONLY.

3.8.1 Power connections

Input/output and DC connections are provided with terminal blocks.
Please refer to chart for torque specifications.
Carefully read the following recommendations before proceeding:
Ensure that the AC and DC external isolators are OFF and locked to prevent their inadvertent
operation.
Do not close any external isolators prior the commissioning of the equipment.
The preferred power cable entry location for installation purposes is from the right side of the UPS,
either top or bottom.
In case of cable entry from the top of the cabinet, remove the cover plate fitted on the roof and
provide for a suitable isolated protection cover.
In case of cable entry from the bottom remove cover plate and perform the same procedure.
The input/output cables must be connected in clockwise phase rotation for both Bypass and
Rectifier Input Terminals if separate, taking care to avoid risk of short circuit between different poles.
The grounding and neutral connection of the electrical system must be in accordance with local
regulations.
In case of additional cabinets containing batteries, input/ output transformers, etc, their ground
terminals must be connected to the UPS main ground terminal.
Once the power cables have been connected, re-install the internal safety shields and close the
cabinets by re-installing all external panels.
UPS rating
SG Series 10 & 20
SG Series 30 & 40
Modifications reserved
GE_UPS_OPM_SGS_ISG_10K_40K_0US_V070.docx
Critical Power
Torque Specifications
Mechanical Terminals
Input / Output / Battery and GND
WIRE SIZE RANGE
20 AWG to 3 AWG
16 AWG to 1 AWG
Lb - in
27
22
Installation Guide SG Series 10-20-30-40 UL S
Nm
3
2.5
Page 24/46

Advertisement

Table of Contents
loading

Table of Contents

Save PDF