Advertisement
Quick Links
Download this manual
See also:
Technical Manual
User Documentation
Technical Manual and other documentation for RER601/603 are available at:
Overview
This document is a short description of how to power up the Wireless Gateway RER601/603
product and how to get it operational. For further information consult the product Technical
Manual.
Physical connections and switches
1
3
2
9
Installing SIM card
NOTE: If you have PIN code querying enabled on your SIM card, do not install the card before
setting the code. The SIM card could lock up if done otherwise. SIM card is not included.
1. Power off the RER601/603. It is recommended to turn power off while installing/removing the SIM
card.
2. Push the yellow button in the SIM card slot to eject the SIM card tray.
3. Insert the SIM card to the tray and push the SIM card tray firmly and carefully back to its holder.
ABB
Wireless Gateway RER601/603
Quick Start Guide
http://www.abb.com/substationautomation
7
5
6
4
10
www.abb.com/substationautomation
Connector panel:
1. Power supply connector
2. Power switch
3. Console/application serial port (RS1)
4. Console/application port selection switch
5. Application serial port (RS2)
6. DIP switches (RS2 hardware settings)
8
7. I/O connector (only on RER603)
8. Ethernet connector
Antenna panel:
9. Antenna connector (FME)
10.SIM card slot
1(4)
1MRS757426 Rev. A
Advertisement
Related Manuals for ABB RER601
Summary of Contents for ABB RER601
-
Page 1: Quick Start Guide
NOTE: If you have PIN code querying enabled on your SIM card, do not install the card before setting the code. The SIM card could lock up if done otherwise. SIM card is not included. 1. Power off the RER601/603. It is recommended to turn power off while installing/removing the SIM card. - Page 2 1. Connect the cross-over Ethernet cable between the RER601/603 and your computer. 2. Configure your computer to use the same IP address space than the RER601/603 (laptop IP for example 10.10.10.11 with netmask 255.0.0.0). Check the connection to the RER601/603 with ping utility.
- Page 3 1. Switch off the RER601/603 if necessary 2. Connect a null modem serial cable to console serial connector (RS1) 3. Open a terminal connection to the RER601/603 using the following serial communication settings: 19200-8-N-1, no flow control. 4. Switch on the RER601/603 by turning the power switch to ON position 5.
- Page 4 Figure 3: GPRS Network Settings Using the RER601/603 as Wireless Access Point 1. Set your Ethernet device to use the IP address of the RER601/603 as its default gateway. 2. Configure your Ethernet device to be in the same network as the RER601/603.