Dell S6000–ON Configuration Manual page 626

Hide thumbs Also See for S6000–ON:

Table of Contents

Dell(conf)#router ospf 1

Dell(conf-router_ospf-1)#timer spf 2 5

Dell(conf-router_ospf-1)#

Dell(conf-router_ospf-1)#show config

router ospf 1

timers spf 2 5

Dell(conf-router_ospf-1)#

Dell(conf-router_ospf-1)#end

For a complete list of the OSPF commands, refer to the OSPF section in the Dell Networking OS

Command Line Reference Guide document.

Enabling OSPFv2

To enable Layer 3 routing, assign an IP address to an interface (physical or Loopback). By default, OSPF,

similar to all routing protocols, is disabled.

You must configure at least one interface for Layer 3 before enabling OSPFv2 globally.

If implementing multi-process OSPF, create an equal number of Layer 3 enabled interfaces and OSPF

process IDs. For example, if you create four OSPFv2 process IDs, you must have four interfaces with Layer

Assign an IP address to an interface.

CONFIG-INTERFACE mode

ip address ip-address mask

The format is A.B.C.D/M.

If you are using a Loopback interface, refer to

Enable the interface.

CONFIG-INTERFACE mode

Return to CONFIGURATION mode to enable the OSPFv2 process globally.

CONFIGURATION mode

router ospf process-id [vrf {vrf name}]

vrf name: enter the keyword VRF and the instance name to tie the OSPF instance to the VRF. All

network commands under this OSPF instance are later tied to the VRF instance.

The range is from 0 to 65535.

The OSPF process ID is the identifying number assigned to the OSPF process. The router ID is the IP

address associated with the OSPF process.

After the OSPF process and the VRF are tied together, the OSPF process ID cannot be used again in

Open Shortest Path First (OSPFv2 and OSPFv3)

Show Quick Links

Table of Contents

Troubleshooting