Make Connections In Power Supply Box - Bosch VG4 Series Installation Manual
Modular camera series
Hide thumbs
Also See for VG4 Series:
- Installation manual (84 pages) ,
- Firmware update manual (42 pages) ,
- Manual (36 pages)
Table of Contents
Advertisement
VG4 Modular Camera Series
2.7
Make Connections in Power Supply Box
Refer to Table 2.2, Page 22 to locate the various connectors in the power supply box and make
the following connections detailed below.
Figure 2.10 Pendant Arm connections to Power Supply Box
1.
2.
3.
Control Data
Alarm Inputs
WARNING!
Do not connect the RJ45 connector unless using UTP video or Ethernet.
4.
Bosch Security Systems, Inc.
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en
1 2 3
Attach the earth ground wire (item 1 in the illustration above) to the grounding screw on
the left side of the power box.
Connect the 6-pin Control In/Out Plug, installed previously, to its mating connector P106
in the power box. If this product is a Fiber Optic model this step is not required, since all
control data is sent through the fiber cable.
Connect the 6-pin Control to Dome Plug from the Pendant Connector Harness to its
matting connector P105 in the power box. (For Fiber Optic model connect to the P106
connector.)
Coax Video
Alarm Outputs
Connect the 5-pin, 24 VAC to Dome Plug from the Pendant Connector Harness to its
corresponding color mating connector P107 on the right side of the box.
Installation Manual
24 VAC Power
UTP Video/Ethernet
Relays
Grounding Strap
F.01U.162.025 | 6.0 | 2010.03
25
Hide quick links:
Advertisement
Table of Contents
