Viewing Igmp Enabled Interfaces; Selecting An Igmp Version - Dell S4820T Configuration Manual
Hide thumbs
Also See for S4820T:
- Manual (60 pages) ,
- Installation manual (59 pages) ,
- Configuration manual (1128 pages)
Table of Contents
Advertisement
•
Fast Convergence after MSTP Topology Changes
•
Designating a Multicast Router Interface
Viewing IGMP Enabled Interfaces
Interfaces that are enabled with PIM-SM are automatically enabled with IGMP.
To view IGMP-enabled interfaces, use the following command.
•
View IGMP-enabled interfaces.
EXEC Privilege mode
show ip igmp interface
Example of the show ip igmp interface Command
Dell#show ip igmp interface TenGigabitEthernet 3/10
Inbound IGMP access group is not set
Internet address is 165.87.34.5/24
IGMP is up on the interface
IGMP query interval is 60 seconds
IGMP querier timeout is 0 seconds
IGMP max query response time is 10 seconds
IGMP last member query response interval is 1000 ms
IGMP immediate-leave is disabled
IGMP activity: 2 joins
IGMP querying router is 165.87.34.5 (this system)
IGMP version is 2
Dell#
Selecting an IGMP Version
Dell Networking OS enables IGMP version 2 by default, which supports version 1 and 2 hosts, but is not
compatible with version 3 on the same subnet.
If hosts require IGMP version 3, you can switch to IGMP version 3.
To switch to version 3, use the following command.
•
Switch to a different IGMP version.
INTERFACE mode
ip igmp version
Example of the ip igmp version Command
Dell(conf-if-te-1/13)#ip igmp version 3
Dell(conf-if-te-1/13)#do show ip igmp interface
TenGigabitEthernet 1/13 is up, line protocol is down
Inbound IGMP access group is not set
Interface IGMP group join rate limit is not set
Internet address is 1.1.1.1/24
IGMP is enabled on interface
IGMP query interval is 60 seconds
IGMP querier timeout is 125 seconds
IGMP max query response time is 10 seconds
414
Internet Group Management Protocol (IGMP)
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
